Rustoleum 7201 Floorcoat PU Primer has been developed as a single pack primer for concrete to increase the durability of Rustoleum's 7200 Floor System.
Solvent-based primer for Rustoleum Floorcoat PU 7200, ideal for dense substrates, like power floated concrete. Suitable as an adhesion and impregnation primer for mineral substrates.
New concrete should have a maximum of 6% moisture content. Remove oil, grease and all other surface contaminations by alkaline or high pressure-(steam)cleaning in combination with appropriate detergents. Remove all laitance, loose or unsound concrete by vacuum-blasting or etching with Rust-Oleum Surfa-Etch 108 Etching Solution. Remove concrete curing compounds completely. Large surfaces should preferably be prepared by abrasive blasting (vacuum blasting) or flame cleaning. Profile maximum 0.5 mm. Defects in the concrete should be repaired with Rust-Oleum Epoxy Repair Mortar 5180 or Rustoleum Pegacrete . Small (hair) cracks
and air-pockets should be repaired with Rustoleum Epoxy Putty 5412. The surface should be clean and dry during application.
|VOC Content:||412.0g per Litre|
|Suitable Substrates:||For dense substrates, like power floated concrete|
|Application Method:||Brush, Roller|
|Theoretical Coverage:||13 m2 per litre|
|Wet Film Thickness (WFT):||77 microns|
|Dry Film Thickness (DFT):||35 microns|
|Touch Dry:||4 hours at 20°C|
|Overcoatable:||After 16 hours at 20°C|
|Fully Cured:||3 days at 20°C|
|Cleaner / Thinner:||Rustoleum Thinner 160|
|Shelf Life:||5 years from date of production in unopened cans, if stored in dry, well ventilated areas, not in direct sunlight at temperatures between 5° and 35°C.|
|Packaging:||Available in 5 Litres|
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.