Bradite Floor Primer ES40 is a high performance two pack water based floor primer for power floated, non-porous concrete and quarry tiles.
Bradite Floor Primer ES40 is formulated for Interior smooth absorbent floor substrates, including dense, power floated, porous concrete, terracotta and quarry floor tiles. that are clean, dry and suitably prepared. Note, this product is not suitable for applying over existing floor paint systems.
Material must be thinned (see specific mixing information on the technical data sheet) prior to application on new or uncoated concrete to enable penetration and binding of substrate. Application and use should always conform to the codes of practice described in BS 6150 and BS 5493.
Brush and Roller – On smooth substrates, the use of a suitably sized foam or short pile roller is highly recommended. Conventional Air & Airless Spraying is not recommended.
Certificates and Approvals
- Manufactured under the auspices of an ISO 9001:2008 quality & ISO 14001:2004 environmental management systems.
- 2004/42/EC EU limit value for this product (cat.A/h wb): 30g/l (2010). This product contains max.2 g/l VOC.
|Finish:||Not applicable, absorbed by surface|
|VOC Content:||<2 g/L|
|Volume Solids:||47% (mixed, after thinning)|
|Suitable Substrates:||Dense, power floated, porous concrete, terracotta and quarry floor tiles. Clean, dry and suitably prepared|
|Application Method:||Brush, Roller, Airless Spray or Air-Atomised Spray|
|Theoretical Coverage:||25 m2/L/coat|
|Wet Film Thickness (WFT):||40 microns/coat|
|Dry Film Thickness (DFT):||Not measureable since absorbed by substrate|
|Pot Life:||1 hour|
|Touch Dry:||1 hour at 20°C|
|Overcoatable:||After 2.5 hours minimum at 20°C|
|Fully Cured:||After 5 days at 20°C|
|Cleaner / Thinner:||Water|
|Shelf Life:||12 months minimum in original unopened containers.|
|Packaging:||Available in 5 Litres|
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.