Please note, this product is now discontinued. Contact our technical team for a suitable alternative.
Bradite Poly Lacquer is a high performance two pack polyurethane solvent based lacquer for mineral substrates, and wood.
Bradite Poly Lacquer PL78 is best used on steel, non-ferrous metals, wood, concrete & mineral substrates which are free of contamination, dust, efflorescence and have been properly prepared & primed. Suitably prepared existing epoxy and polyurethane coatings. It is also suitable for bar tops and dance floors.Compatibility with existing coatings should be confirmed by preparing and painting a test patch.
Please note, Bradite Poly Lacquer is not suitable for applying over asphalt, bitumen, epoxy tar, alkyd, chlorinated rubber or vinyl based paints.
Application and use should always conform to the codes of practice described in BS 6150 and BS 5493.
High pressure steam cleaning to remove all loose, flaking paint and contamination back to a sound surface. Bradite TD39 industrial strength detergent, washing and rinsing should be used with scrubbing to remove grease or oil. Sound existing coating should be additionally abraded to provide a key.
- 1st coat Bradite Poly Lacquer PL78, thinned 20% with TP33, if required
- 2nd coat Bradite Poly Lacquer PL78
For maintenance painting the 1st coat will be a touch up to bare areas only.
- Tough, hard-wearing flexible film with excellent weathering resistance.
- Good chemical resistance and excellent water resistance.
- Can be used as an anti-graffiti coating on suitable substrates.
- Cures at low temperatures
|Finish:||Full Gloss (>90%) PL78 or Semi-Gloss (50%) PL78S|
|VOC Content:||405 grams per litre|
|Volume Solids:||45% (mixed)|
|Suitable Substrates:||Steel, non-ferrous metals, wood, concrete|
|Application Method:||Brush, Roller, Spray|
|Theoretical Coverage:||15 m2/L/coat|
|Wet Film Thickness (WFT):||67 microns/coat|
|Dry Film Thickness (DFT):||30 microns/coat|
|Pot Life:||2 hours at 20°C|
|Surface Dry:||1 hour at 20°C|
|Overcoatable:||After 12 hours minimum at 20°C|
|Cleaner / Thinner:||Bradite Thinner TP33|
|Shelf Life:||12 months minimum in original unopened containers|
|Packaging:||Available in 2.5 Litres|
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.