£7.75 delivery on orders excluding certain products & postcodes *
Bradite Roadline CR27 is best used on roads, runways, car parks and sports facilities. It is suitable for use on asphalt, concrete and brick.
Application and use should always conform to the codes of practice described in BS 6150 and BS 5493.
Substrates should be dust free and completely dry before coating. When painting concrete, it is vital to ensure that the substrate is completely dry and free of laitance. Power floated, shiny or unpainted non-porous concrete floors should be thoroughly vacuum blast cleaned to a roughness profile of 30-50 microns, or acid etched, or primed. Please consult the product data sheet for more details. High pressure water cleaning should be utilised to remove all loose and flaking paint and contamination back to a sound substrate. Industrial strength detergent should be used if necessary to remove all grease and oil. Intact areas of existing coatings should be roughened by abrasive manual or disc rubbing and feathered back to a sound coating edge. Cracks and pits should be filled using a suitable screed or mortar before painting.
For application on concrete or other absorbent substrates, the first coat should be thinned 15-20% with Bradite Thinner TB34 to allow penetration into the substrate.
For maintenance painting, the 1st coat will be a touch up to bare areas. While the coating will take light foot traffic after overnight drying, full cure may take 4 days at 20⁰C, and should not be subject to heavy traffic for at least 24 hours. Please note that drying/curing times will vary depending on film thickness, temperature and relative humidity.
Components: | Single Pack |
Type: | chlorinated rubber |
Finish: | Eggshell (approx. 20%) |
Stock Colours: | White, Yellow |
Tintable: | Yes. Please contact us for details. Please note, bespoke tints are non refundable / exchangeable |
VOC Content: | 430 g/L |
Volume Solids: | 50% |
Suitable Substrates: | For internal & external asphalt, steel, concrete and other absorbent mineral substrates |
Application Method: | Brush, Roller, Airless Spray |
Theoretical Coverage: | 5 m2 per Litre per Coat |
Wet Film Thickness (WFT): | 200 microns/coat |
Dry Film Thickness (DFT): | 100 microns/coat |
Induction Time: | - |
Pot Life: | - |
Surface Dry: | 10 minutes at 20°C |
Overcoatable: | After 1 hour minimum at 20°C |
Fully Cured: | 4 days at 20°C |
Cleaner / Thinner: | Bradite Thinner TB34 (clean with Bradite Thinner TC32) |
Shelf Life: | 12 months from date of production unopened |
Packaging: | Available in 5 Litres |