Bradite Cladit plus Semi-Gloss is a two pack polyurethane high build acrylic finish and coating. It produces a tough, hard wearing coating that is recoatable even after long periods of exposure, for long lasting protection of exterior elevations on buildings and structures.
Bradite Cladit + Semi Gloss is best used on exterior cladding requiring a hard wearing, flexible, weather and light resistant coating. It has excellent adhesion to existing cladding coatings (coil, plastisol and powder coatings) with minimal preparation.
Suitable for use over most existing cleaned and prepared cladding coating systems. Compatibility with existing coatings should be confirmed by preparing and painting a test patch. Bare steel and non-ferrous metals should be properly prepared and primed before painting with this product.
Always aim to paint an elevation preceding direct sunlight illumination to prevent painting onto warm surfaces which may cause too rapid drying and detract from application properties and finish appearance quality. Application and use should always conform to the codes of practice described in BS 6150 and BS5493.
High pressure water cleaning to remove all loose and flaking paint and contamination back to a sound substrate. Bradite TD39 industrial strength detergent washing and rinsing should be used with scrubbing to remove grease or oil. Check & confirm adhesion of apparently sound cladding coating by carrying out cross hatch adhesion test to all elevations. If adhesion is suspect then elevation should be completely stripped of old coating and repainted.
Intact areas of existing coatings should, ideally, be roughened by manual or mechanical sanding. Feather back exposed areas to a sound coating edge. Cracks and pits should be filled using a suitable filler before painting. Substrate should be dust free and completely dry before coating.
Exposed ferrous substrate should be blast cleaned to SIS Sa21/2 or manually cleaned to SIS St3, then patch primed with Bradite Surface Tolerant Epoxy Primer EP92*.
Certificates & Approvals
- Manufactured under the auspices of an ISO 9001:2008 quality & ISO 14001:2004 environmental management systems.
- 2004/42/EC EU limit value for this product (cat.A/d sb): 300g/l (2010). This product contains max.198 g/l VOC.
|Stock Colours:||BS and RAL Colour Range|
|Tintable:||Yes. Please note, bespoke tints are non refundable / exchangeable|
|VOC Content:||198 g/L|
|Suitable Substrates:||Direct application to most external cladding including Plastisol and PVF2|
|Application Method:||Brush, Roller & Spray|
|Theoretical Coverage:||10m2 per Litre|
|Wet Film Thickness (WFT):||100 microns/coat|
|Dry Film Thickness (DFT):||53 microns/coat|
|Pot Life:||6 hours|
|Touch Dry:||1 hour at 20°C|
|Overcoatable:||After 12 hours minimum at 20°C|
|Fully Cured:||7 days at 20°C|
|Cleaner / Thinner:||Bradite Thinner TP33|
|Shelf Life:||12 months minimum in original unopened containers|
|Packaging:||Available in 5 Litres|
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.