Tensid Cladex LD is a pH neutral cleaning product formulated on the basis of surface active substances. It is biodegradable, formulated to remove atmospheric soiling and is ideal for maintenance cleaning.
Tensid Cladex LD is recommended for cleaning medium soiled plastic type surfaces, coated and painted surfaces. Also suitable for anodised aluminium and other types of metal based cladding materials.
Always test each type of surface to ensure suitability and desired results. For initial cleaning, depending upon level of soiling, maximum dilution 1:5. For maintenance Cleaning maximum dilution 1:20. Apply the soloution with a sponge or low pressure sprayer. Leave for a few minutes, some agitation may be required. Do not allow the product to dry on the surface. Rinse thoroughly with clean water. Note: For heavily soiled surfaces use Cladex HD.
- Minimum air temperature 50°C
- Maximum relative humidity 100%
- Minimum surface temperature 50°C
- Maximum surface temperature 300°C
|Type:||Neutral Cladding Cleaner|
|Finish:||Appearance is a light yellow liquid|
|Suitable Substrates:||Medium soiled plastic, coated and painted surfaces and anodised aluminium|
|Application Method:||Sponge or low pressure sprayer|
|Theoretical Coverage:||Approximately 10m2 per litre|
|Wet Film Thickness (WFT):||-|
|Dry Film Thickness (DFT):||-|
|Fully Cured:||Leave product on for a few minutes but do not allow to dry on the surface|
|Cleaner / Thinner:||-|
|Shelf Life:||12 months in a tightly sealed unopened container|
|Packaging:||Available in 10 Litres|
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.