Centrecoat Fastpatch Concrete Repair Mortar

SKU
id23968
Part A: UN3082 (Class: 9, Pk Grp: III), Part B: UN2735 (Class: 8, Pk Grp: III)
Formulated for rapid and permanent repairs to concrete and masonry surfaces.
Available in 5 Kg in Grey
From £49.46 £41.22
In stock
Only %1 left
Product Description

Centrecoat Fastpatch is a high strength, trowel applied, two component epoxy resin mortar, formulated for rapid and permanent repairs to concrete and masonry surfaces.

Best Uses

Centrecoat Fastpatch is suitable for the repair of spalled or damaged concrete, chemical bunds, bedding pre-cast concrete beams, nosings on expansion joints and general floor repairs.

  • Ready to use
  • Fast curing characteristics
  • Impact and abrasion resistant
  • Frost resistant and impervious to water
  • Excellent mechanical properties
  • Unaffected by a wide range of acids, and industrial chemicals
  • Negligible shrinkage
  • High bond strength – no primer required
  • Cures under damp, cool conditions

Centrecoat Fastpatch is a blend of epoxy resin, polyamine curing agent, graded aggregate and colour pigments. The mixed material is applied to a suitably prepared surface, and quickly cures to form a durable, abrasion and chemical resistant repair.

Application

Remove all laitance, spalled concrete, grease, oil, dust, and other contaminants by scabbling or bush hammering, to provide a sound, clean, substrate. Any exposed reinforcing steel shall be fully exposed by cutting out around its full circumference, and cleaned by abrading or grit blasting to remove rust, scale, etc.

Primer not normally required. For exceptionally porous surfaces, please contact our Technical Department for specific advice.

Centrecoat Fastpatch is supplied as a two component pack. Each component is pre-weighed and ready to mix. The contents of the CURING AGENT should be
added into that containing the BASE and the two components thoroughly mixed, by spatula or low speed drill/stirrer, or forced action mixer.

Apply the Centrecoat Fastpatch by tamping and trowelling to ensure good compaction and a tight finish. The material should not be feather edged. Maximum thickness in horizontal applications is 50mm. For vertical applications the material may be built up in layers not exceeding 6mm.

Clean equipment with Centrecoat MMA Tool Cleaner prior to curing of the mortar.

Technical Details
Components: Two Pack
Type: Mortar
Finish: -
Stock Colours: Grey
Tintable: No
VOC Content:
Volume Solids:
Suitable Substrates: Concrete
Application Method: Tamper and Trowel
Theoretical Coverage: A 5kg pack of Centrecoat Fastpatch yields 2.5 litres of material, sufficient for 0.5m² @ 5mm thickness.
Wet Film Thickness (WFT): -
Dry Film Thickness (DFT): -
Induction Time: -
Pot Life: 40 minutes at 20°C
Full Traffikable: 5 - 6 hours at 15-20°C
Cleaner / Thinner: Clean equipment with Centrecoat MMA Tool Cleaner prior to curing of the mortar.
Shelf Life: Centrecoat Fastpatch has a minimum shelf life of 12 months when stored in original, unopened containers in accordance with manufacturer’s instructions.
Packaging: Available in 5 Kg
Product Video

Related Products