Remmers Restoration Mortar

SKU
id17864
Non Hazardous
A ready-to-use, pre-mixed, dry mortar made of mineral raw materials (binder and aggregates).
Available in 15 Kg
From £106.20 £88.50
In stock
Only %1 left
Product Description

Remmers Restoration Mortar is a ready-to-use, pre-mixed, dry mortar made of mineral raw materials (binder and aggregates). 

Please note, this product has a minimum order quantity of 2 x 15 Kg bags.

Best Uses

Remmers Restoration Mortar is used for restoring, supplementing and re-profiling mineral substrates such as natural stone, brick, concrete and synthetic stone. It can also be used to reproduce ornamental building elements in a tamping procedure.

Its physical characteristics correspond to the requirement for the lowest possible inherent stress and physical-mechanical properties that are coordinated to the natural stone substrate (compressive and bonding strength, water transport, etc.).

Application

A general prerequisite for working with Remmers Restoration Mortar is a load-bearing substrate (balanced strength profile). This can be achieved by preparing the stone with a stone mason's tools or by consolidating the stone and, if necessary, by combining treatment with Remmers Antihygro.

Preliminary restoration work

For valuable heritage surfaces that would lose their surface characteristics if the substrate were prepared using stone mason's tools, the substrate can be prepared by consolidating the stone with the Remmers Silicic Acid Ester System. The exact procedure for this must be determined for the specific object.


Preparation with stone mason's tools

The areas to be restored with Restoration Mortar should be cut out at an appropriate angle with a chisel or fly-wheel cutter. The damaged, weathered areas should be scabbled out down to sound stone. Edge areas should not taper off to zero if possible. Supporting reinforcement in the form of plastic star dowels or stainless steel should only be used on strongly cantilevered elements such as cornices, etc. These are anchored with plastic dowels or thickened Remmers Epoxy BH 100.

Technical Details

Notes

  • Always set up a trial area. There may be slight deviations in the shade of colour of different batches.
  • When applying to an entire surface, use only the same batches the same day; otherwise the batches must be mixed.
  • For use both indoors and outdoors
  • Setting should be monitored, especially in warmer weather. Moistening at least twice a day for the first four days is necessary to prevent the mortar from drying out too quickly. 

Technical Info

Components: Single Pack
Type: Dry Mortar
Finish: -
Stock Colours: Medium Grey, Off-white, Yellow Ochre, Red Brown, Beige, Brick Orange, Anthracite and others
Tintable: Yes - Please call for further information. Please note, bespoke tints are non refundable / exchangeable
VOC Content: -
Volume Solids: -
Suitable Substrates: Natural Stone, Brick, Concrete & Synthetic Stone
Application Method: Mortar Cover, Filling Knife or Trowel
Theoretical Coverage: Standard Colours approx. 1.8 kg/l void
Wet Film Thickness (WFT): -
Dry Film Thickness (DFT): -
Induction Time: -
Working Temperature: Between +5°C and +25°C
Touch Dry: -
Overcoatable: -
Fully Cured: After 3-4 weeks at 20°C
Cleaner / Thinner: Clean tools with water whilst material is still wet
Shelf Life: 12 months stored dry in closed bags
Packaging: Available in 15 Kg bags

Related Products