Rustoleum Speed Screed for Floors

Rustoleum Speed Screed For Floors is a Concrete Repair for uneven, damaged or worn out concrete and power floated floors and can be applied from 3mm to 15mm thick. 

Rustoleum Speed Screed For Floors is a Concrete Repair for uneven, damaged or worn out concrete floors. Anglo Speed Screed is a professional quality pour on durable re-surfacing material. Rough concrete floors can be transformed rapidly and easily with this self-smoothing, hard wearing material designed to meet the demands of industrial use.

Best Uses

Rustoleum Speed Screed is pre-blended for easy mixing and fast application and it provides a mid grey, non-dusting, slip-resistant surface that requires no further treatment before use. Rustoleum Speed Screed can be applied from 3mm to 15mm thick. Best used as for concrete repair, bringing life back to damaged concrete floors, internally or externally.

• Extremely durable
• Foot traffic possible after 6 hours
• High mechanical strength
• Low odour
• From 3 – 15 mm thickness possible

Application

Concrete should be free of loose material, soft surface laitance and contaminants. New concrete must be at least four weeks old. Remove all loose material by wire brushing. General dirt etc, should be removed with a strong neutral cleaner. Oil and grease can be removed with Rustoleum  ND14 Cleaner/Degreaser. Cracks in concrete should be raked out and all loose material removed.

Priming: Two primers are supplied. Dampen areas of bare concrete with clean cold water and leave for 20 - 30 minutes prior to applying Primer 1. Apply Primer 1 to the prepared surface using a brush or soft broom. Apply the Primer evenly avoiding ‘ponding’ on the surface and allow it to dry. Then apply Primer 2.

Mixing: (immediately after Primer 2 has been applied) Pour the resin into the empty Speed Screed container. Add the powder to the liquid slowly and blend in using a slow speed electric drill fitted with a paint stirrer until a completely even colour and consistency is obtained (3 to 5 minutes).

Pour the mixed components onto the wet Primer 2. Use a trowel to spread the Speed Screed across the surface of the concrete at the desired thickness (it may be convenient to work to a thin batten but this must be removed before working further sections). It is not essential that trowel marks are removed at this stage.

Immediately after application a spiked roller should be used to even out the material and release any trapped air. Use the spiked roller quite vigorously rolling each area 3 or 4 times from different directions. The spiked
roller should not be used for more than 20 minutes as the Speed Screed will have started to cure and the roller may leave marks. If it is necessary to walk on areas of wet primer whilst applying Speed Screed care should be taken not to tread wet primer or Speed Screed onto surrounding surfaces. In exceptional temperature conditions advice should be obtained from
our Technical Department.

Surface/Environment

Rustoleum Anglo Speed Screed is a Concrete Repair suitable for repairing concrete floors, internally and externally. Once fully cured Speed Screed can be kept clean easily with degreasers and detergents.