£7.75 delivery on orders excluding certain products & postcodes *
Firetex 5000 is formulated to provide up to 60 minutes fire protection to structural steel. For use in internal dry controlled environments without topcoat (C1 according to ISO 12944-2:1998) and internal semi controlled environments with topcoat (C2 according to ISO 12944-2:1998)
Must not be applied directly to galvanized steel and zinc rich primers. Recommended application method via airless spray or brush. Thin with water but thinning with have an adverse effect on sag tolerance. If can be guaranteed that application and subsequent in-service conditions will be in a C1 environment as defined in ISO 12944-2:1998, then no topcoat is required. FIRETEX FX5000 must be applied in a dry internal environment. It must not be exposed to condensation, damp or wet conditions during or after application. In conditions of high relative humidity good ventilation conditions are essential. Substrate temperature shall be at least 3°C above the dew point and always above 0°C. At application temperatures below 10°C, drying and curing times will be significantly extended, and spraying characteristics may be impaired. A minimum ambient air temperature of 5°C is required to ensure proper film formation.
Recommended topcoats include Sher-Cryl M770, FIRETEX M71V2, Acrolon C137V2 or C237.
Macropoxy M630V2 can be used for internal areas where regular water washing down for hygiene reasons is required. Maximum temperature of water used should be not more than 60°C and water ponding on the coated steelwork must be avoided.
IMPORTANT INTUMESCENT PRODUCT NOTE: Always contact Promain’s technical team prior to purchase to obtain a tailored project specification and the advice necessary. The information displayed on this website should only be used as a guide. Promain UK Limited will not be held liable for any resulting damage to property, human life or monetary costs incurred due to incorrect specification, preparation, application or maintenance that has occurred due to negligence by either the purchaser or applicator. This includes your failure to have contacted us to obtain the relevant advice/specification.
Components: | Single Pack |
Type: | Water Based Intumescent |
Finish: | - |
Stock Colours: | White |
Tintable: | No |
VOC Content: | 55 gms/litre |
Volume Solids: | 70 ± 4% |
Suitable Substrates: | Structural Steel |
Application Method: | Brush, Airless Spray |
Theoretical Coverage: | See separate sheets of FX5000 loading requirements |
Wet Film Thickness (WFT): | Spray: 1400 microns, Brush: 429 microns |
Dry Film Thickness (DFT): | Spray: 1000 microns, Brush: 300 microns |
Induction Time: | - |
Pot Life: | - |
Touch Dry: | 3 hours at 15°C |
Overcoatable: | 6 hours at 15°C |
Fully Cured: | - |
Cleaner / Thinner: | Wtaer - Thinning will have an adverse effect on sag tolerance. |
Shelf Life: | 6 months from date of production unopened or 'use by' date where specified |
Packaging: | Available in 20 Litres |