Sherwin Williams Firetex FX13381-1 is a single pack thin film intumescent coating to provide 120 minute of fire resistance to structural steel.
FIRETEX FX13381/1 is designed for site application by airless spray, to provide fire resistance for up to 120 minutes on structural steel. For use without topcoat in dry internal areas - category Z2 as defined in ETAG 018-2. For use with topcoat in internal areas with high humidity, semi exposed areas and in fully exposed areas - categories Z1, X and Y as defined in ETAG 018-2.
FIRETEX FX13381/1 can resist normal weather conditions for up to 6 months without topcoat provided it has had appropriate drying prior to exposure. Once an approved topcoat has been applied as appropriate to the prevailing conditions, then durability will be substantially enhanced. If the specific use or storage could lead to prolonged contact with water due to rainfall, condensation, or other site/transportation/storage circumstances, then a recommended topcoat must be used to prevent damage to the basecoat.
Recommended application via airless spray. Recommended thinner no2. For certain dry, internal situations where the final colour/ appearance is not critical, then FIRETEX FX13381/1 may remain un-topcoated. For externally exposed steelwork and severe internal environments Acrolon C137V2 or Acrolon C237 must be used as a topcoat.
For other internal environments where a topcoat is required then FIRETEX M71V2 or Sher-Cryl M770 should be used. In all instances for subsequent re-decoration, use FIRETEX M71V2, Acrolon C137V2 or Acrolon C237 as appropriate. FIRETEX FX13381/1 is designed for use over a suitably prepared and primed substrate. Ensure surfaces to be coated are clean, dry and free from all surface contamination. Under certain circumstances it may be possible to apply FIRETEX FX13381/1 directly to steel blast cleaned to a minimum standard of Sa2½ BS EN ISO 8501-1:2007, surface profile in the range 50-100 microns.
IMPORTANT INTUMESCENT PRODUCT NOTE: Always contact Promain’s technical team prior to purchase to obtain a tailored project specification and the advice necessary. The information displayed on this website should only be used as a guide. Promain UK Limited will not be held liable for any resulting damage to property, human life or monetary costs incurred due to incorrect specification, preparation, application or maintenance that has occurred due to negligence by either the purchaser or applicator. This includes your failure to have contacted us to obtain the relevant advice/specification.
- Tested and assessed to EN13381-8:2010
- Tested to BS EN 13823:2002
- Drying Times: 30 minutes to touch at 15°C, 4 hours to recoat at 15°C.
- Available in White
- Available in 20 Litres
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.