Owatrol D1 Pro

SKU
id9922
Non Hazardous
A solvent based UV resistant long lasting saturating wood oil for interior and exterior wood.
Available in 1, 5 and 20 Litres in Honey Gold
From £36.22 £30.18
In stock
Only %1 left
Product Description

Owatrol D1 Pro is a solvent-based, saturating wood oil, offering long-term protection and UV resistance to interior and exterior wooden substrates, including, hardwood, softwood, and some tropical hardwoods, such as ipe, teak, bangkirai and mahogany.

Owatrol D1 Pro is a solvent-based, saturating wood oil, offering long-term protection and UV resistance when applied to interior and exterior wooden substrates. D1 Pro is available in a Honey Gold colour to help reduce the effects of UV degradation that causes the timber to become grey over time

Best Uses

Owatrol D1 Pro is extremely versatile and can be applied to a variety of different appliances, including garden furniture, fences, cladding, floors, stairs, doors, door frames, window frames, and decking, to name a few. Owatrol D1 Pro offers excellent penetration for a long lasting natural finish.

Application

Surfaces must be clean, dry and free of dirt, grease, grime, mildew and previous coatings. Treat mildew with a 50/50 bleach/water solution. Scrub solution on to surface and allow to stand for 10-15 minutes; rinse thoroughly. After cleaning, allow wood to dry 2-3 good drying days or until it has reached a moisture content of 18 % or less before applying Owatrol D1 Pro.

Owatrol D1 Pro may only be applied to bare wood surfaces or a weathered wood surface that was previously finished with Owatrol D1 Pro. ALL other finishes must be completely and thoroughly removed. If necessary sand surface after cleaning and/or stripping (80 grit paper).

New wood surfaces:
New wood surfaces have a hard shiny surface called mill-glaze that prevents maximum penetration and adhesion of any finish, this should be removed to ensure maximum performance the finish. Treat with Owatrol Aquanett or Owatrol Prepdeck and neutralise with Owatrol Net-Trol.

Weathered wood surfaces (untreated):
Wood that has weathered longer than 12 months or turned grey should be cleaned with Owatrol Net-Trol to remove all loose wood fibres, dirt and other surface contaminants. If wood is severely contaminated, clean with Owatrol Prepdeck or Owatrol Aquanett and neutralise with Owatrol Net-Trol.

Previously oiled surfaces:
All other oils or sealers must be completely and thoroughly removed with Owatrol Aquanett or Owatrol Prepdeck and the stripped surface neutralised with Owatrol Net-Trol.

Previously coated surfaces (paint, stain, varnish...):
All previous coatings must be completely and thoroughly removed with Owatrol DilunettOwatrol Prepdeck or Owatrol CDKP 90.

Solvent (oil or alkyd based finishes): Strip with Owatrol Dilunett neutralise with Owatrol Net-Trol.
Acrylic finishes - Water-based: Strip with Owatrol Prepdeck neutralise with Owatrol Net-Trol.
Other finishes i.e. 2 pack epoxies, urethanes… Strip with Owatrol CDKP 90.

Note: Hardwoods inc’ exotic hardwoods and woods rich in tannins i.e. Oak, Chestnut, Teak, Ipe, Bangkarai… may darken with Owatrol AquanettOwatrol Prepdeck or Owatrol Dilunett, neutralising with Owatrol Net-Trol immediately after rinsing will lighten and restore the woods colour.

Interior
Thoroughly remove any existing coatings with Owatrol CDKP 90 or by mechanical abrasion. Sand surface with 80 or 100 grit paper to open the woods’ pores.
Dust off and wash with Methylated Spirits (Denatured Alcohol), Acetone or similar (NOT White Spirit) to degrease the surface. Allow to dry.

Surface and Environment

Owatrol D1 Pro can be applied to a number of surfaces including, hardwood, softwood, and some tropical hardwoods, such as ipe, teak, bangkirai and mahogany. With non drip properties, Owatrol D1 Pro can be applied to vertical surfaces as well as horizontal.

Technical Details

Properties

  • Can be used on horizontal or vertical surfaces
  • High UV resistance
  • Honey Gold tint to reduce UV degradation
  • Ideal for dense, greasy or difficult to impregnate hardwood
  • Long lasting natural finish
  • Excellent penetration
  • Non film building. Must be in the wood not on the surface
  • Suitable for interior and exterior application
  • Mildew resistant finish
  • Easy to use
  • Easy to maintain (no stripping, no sanding)
  • Allows local touch up

Use

  • Tropical hardwoods such as Ipe, Teak, Bangkirai, Mahogany
  • Exterior woodwork Decking, Garden Furniture, Fences, Cladding
  • Interior wooden surfaces such as Floors, Stairs, Door & Window Frames
  • Horizontal & Vertical Surfaces

Technical Info

Components: Single Pack
Type: Solvent Based Wood Oil
Finish: Matt
Stock Colours: Honey Gold
Tintable: No
VOC Content: 628 grams per litre
Volume Solids: 32%
Suitable Substrates: For interior and exterior wood
Application Method: Brush, Roller, Airless Spray or HVLP
Theoretical Coverage: Initial: 1 to 4 m2 per litre
Maintenance: 8 to 12 m2 per litre
Actual coverage will vary depending on application method, type, texture, age and porosity of the wood.
Wet Film Thickness (WFT):  
Dry Film Thickness (DFT):  
Induction Time: -
Pot Life: -
Surface Dry: 24 hours at 20°C
Overcoatable:  
Fully Cured:  
Cleaner / Thinner: Clean all tools and equipment with white spirit whilst still wet. If allowed to dry remove with paint stripper.
Any rags etc soaked in D.1 PRO may spontaneously catch fire if improperly discarded. Rags etc must be saturated with water
or placed in a sealed water filled container and disposed of according to local regulations.
Shelf Life: 5 years in original unopened packaging. Left over D.1 PRO should be transferred to a smaller, airtight, closed metal or glass container. Keep from freezing and high temperatures.
Packaging: Available in 1, 5 and 20 Litres

Related Products