£7.75 delivery on orders excluding certain products & postcodes *
Sika SikaTop Armatec 110 EpoCem is formulated for concrete repair as corrosion protection for reinforcement. It is suitable as a bonding primer on concrete and mortar.
Sika SikaTop Armatec 110 EpoCem is suitable for control of anodic areas (Principle 11, method 11.1 EN 1504-9).
Concrete:
The concrete shall be free from dust, loose material, surface contamination and materials which reduce bond or prevent suction or wetting by repair materials. Delaminated, weak, damaged and deteriorated concrete and where necessary sound concrete shall be removed by suitable means. The surface shall be thoroughly pre-wetted and not be allowed to dry before application of the concrete repair mortar. The surface shall achieve a dark matt appearance without glistening and surface pores and pits shall not contain water.
Steel reinforcement:
Rust, scale, mortar, concrete, dust and other loose and deleterious material which reduces bond or contributes to corrosion shall be removed and reinforcement
cleaned to SA 2 in accordance with ISO 8501-1. Surfaces shall be prepared using abrasive blast cleaning techniques or high pressure water-blasting.
SikaTop® Armatec®-110 EpoCem® can be mixed with a low speed (< 250 rpm) electric drill mixer. Shake components A and B thoroughly before opening. Pour liquid components A and B into a suitable mixing vessel and mix for 30 seconds. While still mixing components A and B slowly add powder component C. Mix the three components together for a minimum 3 minutes, minimising addition of air. Leave to stand for 5–10 minutes until mixed coating material exhibits a brush-able, weakly dripping consistency. DO NOT ADD WATER.
As reinforcement corrosion protection:
Apply the first layer approx. 1 mm thick, using medium hard brush or spray gun to the cleaned reinforcement. Apply 2nd layer when the first coat is fingernail hard (~2–3 hours at +20 °C). Apply subsequent repair mortars wet on dry (so not to wipe off the protection layer).
As a bonding primer:
Apply using medium hard brush or spray gun to prepared substrate. To achieve good bond, SikaTop® Armatec®-110 EpoCem® must be applied well into the substrate, filling all pores (minimum layer thickness 0.5 mm). Apply subsequent repair mortars wet on wet Freshly applied SikaTop® Armatec®-110 EpoCem® must be protected against contamination and rain until application of the repair mortar.
Application under dynamic loading:
SikaTop® Armatec®-110 EpoCem® has been tested with the following Sika repair mortars and is certified for dynamic loading applications. Refer to separate product data sheets for further information.
SikaTop® Armatec®-110 EpoCem® is part of an extensive range of Sika Products available from Promain.
Components: | Three Pack |
Type: | Cementitious Epoxy Resin |
Finish: | |
Stock Colours: | Cement Grey |
Tintable: | No |
VOC Content: | - |
Volume Solids: | - |
Suitable Substrates: | For concrete and steel |
Application Method: | Hard Brush, Spray |
Theoretical Coverage: |
As reinforcement corrosion protection coating: ~ 2 kg per m2 and application layer (~1 mm thick)
|
Wet Film Thickness (WFT): | - |
Dry Film Thickness (DFT): | - |
Induction Time: | - |
Pot Life: | 30 hours at 20°C |
Surface Dry: | |
Overcoatable: | |
Fully Cured: | |
Cleaner / Thinner: | Clean all tools and application equipment with water immediately after use. Hardened material can only be mechanically removed. |
Shelf Life: | 1 year in original unopened containers |
Packaging: | Available in 20 Kg |