Remmers Epoxy ST 100

Remmers Epoxy ST 100 is a transparent priming and mortar resin floor primer for use within the Remmers OS 8 System.

Best Uses

Remmers Epoxy ST 100 is an unpigmented epoxy resin binder that is used as an impregnation agent, primer, bonding layer, levelling layer and for the production of compression resistant mortars, flow covers and as a blinding layer for blinded covers.

• Low viscosity
• Good penetration capacity
• Plasticiser free
• Nonylphenol and alkyl phenol free
• Can be subjected to mechanical loads
• Can be subjected to chemical loads

Remmers Epoxy ST 100 application examples include flooring in consumer markets, workshops, stairs with heavy traffic, production halls, assembly areas, shipyards and warehouses for heavy goods.

Application

The substrate must be load-bearing, form-stable, sound, free of loose constituents, dust, oil, grease, rubber marks and other substances with a separating effect. Tensile strength of the surface of the substrate must be 1.5 N/mm² on average and compressive strength at least 25 N/mm². The substrate must have achieved its moisture balance and be protected from the effects of moistures from behind, also during utilisation.

• Concrete max. 4% by mass
• Cement screed max. 4% by mass
• Anhydrite screed max. 0.3% by mass
• Magnesite screed 2 - 4% by mass

In the case of anhydrite and magnesite screeds it is essential that the penetration of moisture from building elements or the ground is not possible.

Prepare the substrate by suitable means, e.g. steel ball jetting or diamond grinding so that it meets the specified requirements. Fill broken out or missing areas in the substrate with the Remmers PCC System or Remmers EP Mortars flush with the surface.

Tin container:
Add the entire quantity of the hardener (comp. B) to the basic component (comp. A). Mix thoroughly with a slow speed electric mixer (max. 300 - 400 rpm). The fill the mixture into a separate container and mix again thoroughly. In the case of filled systems, the cor-responding quantity of filler is added to the epoxy resin mixture while mixing slowly. Mix thoroughly.

Multi-chamber bag:
Open the outer packaging at the notch and take out the transparent, multi-chamber bag. Remove the divider clip on the 2-component bag. Then mix the two components together in the bag thoroughly by kneading the bag (approx. 60 sec.) Then pour the thoroughly mixed material over the prepared surface and distribute with a suitable tool.

See product data sheet for application examples and methods.