Rustoleum 5800 Epoxy Rapid WB

SKU
ID9875
Non Hazardous
A two component, rapid curing, water-based, epoxy coating designed for industrial and warehouse concrete floors.
Avaliable in 5 Litres
From £143.40 £119.50
In stock
Only %1 left
Product Description

Rustoleum 5800 Epoxy Rapid WB is a 2 component, rapid curing, water-based, epoxy coating designed for industrial and warehouse concrete floors.

Best Uses

Rustoleum 5800 Epoxy Rapid WB is ideal for use in different conditions where there is often a high level of moisture content or regular foot traffic, with excellent resistance to both moisture and abrasion.

  • Durable epoxy floor
  • Can be recoated after just 3 hours
  • Available in gloss finish
  • Water-based, very low odour
  • Excellent flow and smooth finish

5800 Epoxy Rapid WB can be applied on cleaned, sound mineral substrates, sound and well prepared previous coatings. The product can be applied directly on porous substrates; a special primer is not needed.

Application

Concrete must be at least 30 days old, completely dry and free of surface laitance, contaminants and previous poorly bonded coatings. Remove grease, oil and all other surface contaminations by alkaline or high pressure (steam) cleaning in combination with appropriate detergents. Sand previous coatings which are in good condition to remove gloss and to roughen the surface slightly, check compatibility. Very smooth concrete or concrete with surface laitance (a weak dusty layer) should be abraded or etched with Surfa-Etch 108 to ensure adequate adhesion. The concrete should be thoroughly washed down and allowed to dry after.

Powerfloat Epoxy Floor Primer 3366 is recommended on powerfloated surfaces

Stir base thoroughly before adding it to the activator. Again stir the mixture thoroughly until an even colour and consistency are obtained. Do not mix more material than can be applied in 2 hours. Higher temperatures will reduce the pot life.

Technical Details
Components: Two Part
Type: Rapid curing epoxy floor paint
Finish: Gloss
Stock Colours: RAL 7035, RAL 7016
Tintable: No
VOC Content: 65.0g per Litre
Volume Solids: 48%
Suitable Substrates: For cleaned, sound mineral substrates, sound and well prepared previous coatings. The product can be applied directly on porous substrates; a special primer is not needed.
Application Method: Brush, Roller
Theoretical Coverage: 6 m2 per litre at 50 microns
Wet Film Thickness (WFT): 167 microns
Dry Film Thickness (DFT): 80 microns
Induction Time: -
Pot Life: 2 hours at 20°C
Touch Dry: 2 hours at 20°C
Overcoatable: After 3 hours, within 5 days at 20°C
Fully Cured: 7 days (traffic possible after 24 hours) at 20°C
Cleaner / Thinner: -
Shelf Life: 2 year from date of production in unopened cans, if stored in dry, well ventilated areas, not in direct sunlight at temperatures between 15° and 25°C. Keep from freezing.
Packaging: Available in 5 Litres

Related Products