Hempel Hempafire Pro 315 Fast Dry 43361 is a one part, solvent borne, intumescent coating, optimised for 60 minutes for protection of structural steel against cellulosic fires. It is suitable for in-shop and on site application.
Hempel Hempafire Pro 315 Fast Dry 43361 is formulated for passive fire protection on structural steel in interior and exterior conditions (Up to C4 conditions ISO 12944-2). Suitable for open profile beams and columns, cellular beams and hollow section beams and columns.
Hempel Hempafire Pro 315 Fast Dry 43361 is also suitable for the repair and touch up coating of damaged areas of freshly applied Hempafire Pro 315 Fast Dry.
Suitable for service down to -10°C and up to 50°C. The product is only available in white, but can be top coated with an approved topcoat in any colour.
The product should only be applied over steel which has been blasted to Sa 2½ (ISO 8501-1) and primed with an approved primer. Remove oil and grease etc. thoroughly with suitable detergent. Remove salts and other contaminants by high pressure fresh water cleaning. Under restrictions St 3 (ISO 8501-1) prepared steel can be acceptable, consult the application instructions for the requirements. Galvanised steel substrates may require other surface preparations, consult the
application instructions for detailed information.
Apply only as part of an approved Hempel fire protection system. Contact our technical team for details.
IMPORTANT INTUMESCENT PRODUCT NOTE: Always contact Promain’s technical team prior to purchase to obtain a tailored project specification and the advice necessary. The information displayed on this website should only be used as a guide. Promain UK Limited will not be held liable for any resulting damage to property, human life or monetary costs incurred due to incorrect specification, preparation, application or maintenance that has occurred due to negligence by either the purchaser or applicator. This includes your failure to have contacted us to obtain the relevant advice/specification.
- Tested and approved according to EN13381-8 and BS 476-21 for up to 90 minutes fire protection. CE marked product with European Technical Approval ETA nº 18/0689 according EAD 350405-00-1106. Approved for up to Type X conditions (all conditions)
|Stock Colours:||White 10000|
|VOC Content:||340 g/L|
|Suitable Substrates:||Internal and External Structural Steel|
|Application Method:||Brush or Airless Spray|
|Theoretical Coverage:||Please discuss with our technical fire team|
|Wet Film Thickness (WFT):||Please discuss with our technical fire team|
|Dry Film Thickness (DFT):||Please discuss with our technical fire team|
|Surface Dry:||Please discuss with our technical fire team|
|Overcoatable:||Please discuss with our technical fire team|
|Fully Cured:||Please discuss with our technical fire team|
|Cleaner / Thinner:||See data sheet. Please discuss with our technical fire team|
|Shelf Life:||12 months 25°C/77°F , thereafter the paint quality is subject to re-inspection|
|Packaging:||Available in 20 Litres|
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.