£7.75 delivery on orders excluding certain products & postcodes *
Suitable for use for pre-treatment of new galvanised steel where blasting or abrasion is not possible. Highways Item No. 155.
PPG Sigma Etch is a high quality etching solution that can be used to give adhesion of high temperature coatings to new galvanised steel that lacks abrasion. As well as this, Sigma Etch can be used as part of a wide range of protective coating systems that can be over coated with many different primers and topcoats.
PPG Sigma Etch is a pale blue solution which blackens after application to indicate the effectiveness of the primary treatment and can be applied easily using a paint brush. Sigma Etch (T Wash) has a theoretical coverage rate of 15m2 per litre.
Sigma Etch mordant solution can be used on all clean, galvanised substrates to etch the surface and provide adhesion, ideal for preparing the substrates ready for a protective and decorative coating.
Components: | One Part |
Type: | Phosphoric Acid Based Etch Solution |
Finish: | - |
Stock Colours: | Pale Blue which turns Grey-Black on application to clean galvanized surfaces |
Tintable: | No |
VOC Content: | 335.0g per Litre |
Volume Solids: | - |
Suitable Substrates: | For pretreatment of new galvanized steel |
Application Method: | Brush, Roller |
Theoretical Coverage: | 15 m2 per litre at 0 microns |
Wet Film Thickness (WFT): | - |
Dry Film Thickness (DFT): | - |
Induction Time: | - |
Pot Life: | - |
Touch Dry: | - |
Overcoatable: | Between 2 hours and 48 hours at 20°C |
Fully Cured: | - |
Cleaner / Thinner: | - |
Shelf Life: | at least 12 months when stored cool and dry |
Packaging: | Available in 5 Litres |