Sherwin Williams Transgard TG111V2 - Formerly Leighs is a high build, 2 pack epoxy, zinc phosphate primer buildcoat for the anti corrosive protection of carbon steel surfaces.
Transgard TG111V2 is best used as an anti-corrosive protection of carbon steel surfaces prepared by abrasive blast cleaning. Can be applied at thicknesses between 75 and 150 microns dry to provide both primer and buildcoat in a single coat. A top coat is only required for decorative purposes. For internal and external applications. Excellent resistance to moisture, petroleum solvents, alkali spillagem aliphatic solvents,, weather and abrasion.
Blast clean to Sa2½ BS EN ISO 8501-1:2007). Average surface profile in the range 50-75 microns. Manually prepared surfaces should be prepared to a minimum standard of St3 ISO 8501-1:2007 at the time of coating. Ensure surfaces to be coated are clean, dry and free from all surface contamination. May also be applied over a wide range of pre-fabrication primers, including inorganic zinc silicate, and epoxy types.Recommended application via airless spray, conventional spray, brush or roller. For overcoating with epoxy products (including self overcoating), the maximum recommended interval is 28 days at 23°C. Where a high degree of gloss and colour retention is required, overcoat with Transgard TG168 or Transgard TG169 within 7 days at a minimum d.f.t. of 50 microns. These overcoating times refer to achievement of optimum adhesion at 23°C and will vary with temperature.
- Highways Agency Item No. 111
- Pot Life: 2.5 hours at 15°C
- Drying Times: 2 hours at 15°C to touch, 6 hours at 15°C to recoat
- Dry Film Thickness: 100 microns
- Theoretical Coverage: 7.5m2 per litre
- Available in Light Grey and Red Oxide
- Available in 5 and 20 Litre units
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.