Mapecoat I 600 W is specifically formulated as a primer for Mapefloor I 500 W when used to form self-levelling, vapour-permeable epoxy coatings (Mapefloor System 53).
Mapecoat I 600 W is a two-component, FeRFA Type 1 - Floor Seal that is opaque in colour. Mapecoat I 600 W is an epoxy resin based finish specially formulated to form a shiny, protective anti-dust and anti-oil film, which is applied directly onto concrete or cementitious systems such as Ultratop. Mapecoat I 600 W is also used to encourage bonding on absorbent and porous cementitious substrates before applying Mapefloor I 500 W.
Mapecoat I 600 W can be applied on concrete substrates without a vapour barrier. After preparation and dilution with water, Mapecoat I 600 W may be applied either by spraying, with a roller or with an airless spray, at a variable thickness from 60 to 100 microns.
- Adhesion promoter for absorbent, porous cementitious substrates.
- As a primer for Mapefloor I 500 W (Mapefloor System 53).
Mapecoat I 600 W is a two-component, water dispersed epoxy-resin based finish in water dispersion primer, made according to a formula developed in MAPEI's own Research & Development laboratories. Mapecoat I 600 W must be cleaned with cold water immediately after use. Once it has set, the product may only be removed mechanically.
- Provides a protective anti-dust finish
- An anti-oil film
- Two pack water-soluble
- Consumption 100-500 g/m2, depending on the absorbency rate of diluted product
- Available in 2 sizes 5.9 kg and 11.8 kits
- Component A = 2.3 kg and 4.6 kg
- Component B = 3.6 kg and 7.2 kg.
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.