*International Interzone 505

SKU id18695 ***
This product is now discontinued.

Product Description

This product is now discontinued. Please contact our technical team for a suitable alternative.

International Interzone 505 is a high solids, low VOC, high build epoxy primer/intermediate or finish coat. Reinforced with chemically resistant high aspect ratio glass flake for enhanced durability and corrosion resistance.

Best Uses

International Interzone 505 is formulated for the protection of steelwork in all corrosive environments including splash zone areas on offshore structures, under deck, decks and above water areas, pilings, pulp and paper mills, bridges and chemical plants.

International Interzone 505 provides excellent long term, anti-corrosive and anti-abrasion protection in both new construction and maintenance situations. Suitable as part of a non-slip deck system in conjunction with appropriate aggregate.

Approved for use as on Highways, Network Rail New Works and London Underground New Works.


The performance of this product will depend upon the degree of surface preparation. The surface to be coated must be clean and free from contamination. Prior to paint application all surfaces should be assessed and treated in accordance with ISO 8504:2000. Accumulated dirt and soluble salts must be removed. Dry bristle brushing will normally be adequate for accumulated dirt. Soluble salts should be removed by fresh water washing. Oil or grease should be removed in accordance with SSPC-SP1 solvent cleaning.

Abrasive Blast Cleaning
Abrasive blast clean to Sa2½ (ISO 8501-1:2007) or SSPC-SP6. If oxidation has occurred between blasting and application of Interzone 505, the surface should be reblasted to the specified visual standard. Surface defects revealed by the blast cleaning process should be ground, filled, or treated in the appropriate manner.
A surface profile of 50-75 microns (2-3 mils) is recommended.

Ultra High Pressure Hydroblasting / Abrasive Wet Blasting
May be applied to surfaces prepared to Sa2½ (ISO 8501-1:2007) or SSPC-SP6 which have flash rusted to no worse than Grade HB2½M (refer to International Hydroblasting Standards) or Grade SB2½M (refer to International Slurry Blasting Standards). It is also possible to apply to damp surfaces in some circumstances. Further information is available from International Protective Coatings.

Recommended Products To Use

International Intercure 200

International Intercure 200

A two component epoxy zinc phosphate / micaceous iron oxide primer suitable for low temperature overcoating.

£273.00 (£327.60 Inc VAT)
International Interfine 629HS

International Interfine 629HS

A low VOC, high performance, two component, isocyanate free cross-linking acrylic finish.

£102.00 (£122.40 Inc VAT)
International Interzinc 22

International Interzinc 22

A two component, rapid recoat, fast curing solvent based inorganic zinc rich ethyl silicate primer.

£434.00 (£520.80 Inc VAT)
International Interline 982

International Interline 982

A two component epoxy holding primer.

£192.00 (£230.40 Inc VAT)
International Intergard 269

International Intergard 269

A quick drying two component epoxy primer for immersed or exposed conditions within a system.

£44.00 (£52.80 Inc VAT)