Sherwin Williams Epidek M689 - Formerly Leighs

SKU
id9226
Part A: UN3082 (Class: 9, Pk Grp: III), Part B: UN2735 (Class: 8, Pk Grp: III)
A 100% solids, two pack epoxy primer / floor sealer for concrete floors.
Available in 4.5 Litres in Clear
£83.86 £69.88
In stock
Product Description

Sherwin Williams Epidek M689 - Formerly Leighs is a 100% solids, two pack epoxy primer / floor sealer for concrete floors.

Best Uses

Sherwin Williams Epidek M689 is formulated for application to suitably prepared concrete substrates as a primer/sealer coat.

Application

Blast track / scabble all surfaces to remove any laitence or contaminated surface layers to expose fresh, sound and firm concrete. The underlying concrete core should be tightly bound and dry, remaining surface dust should be removed by brushing or further vacuum cleaning. Fibre filled concrete must be treated specially, please consult our technical team.

The moisture content should be checked in at least two places within each section of concrete. The sections will normally be separated by a waterproof membrane. The maximum level acceptable is 7% for the application of M689 Sealer coat.

Where previous coatings have been applied, these must be completely removed prior to application of the M689 based systems. Any areas of floor which are pitted, very rough, or have any large blow holes, should be smoothed off using a 5:1 by weight blend of P515:M689 prior to application of the Epidek M689 Primer. It is recommended that prior to application of Epidek M689 systems contact is made with Sherwin-Williams.

Due to the varying nature of concrete substrates, it is to be advised that a small trial area is prepared of the Epidek M689 system prior to coating the entire floor area. Recommended application via roller or float.

Recommended topcoats: Macropoxy M630V2, Epidek M153, Macropoxy M262, Epidek M339, Epidek M377, Epidek M689 must be overcoated within 3 days at 23°C or 4 days @ 15°C.

Recommended thinner Sherwin Williams Thinner No 5.

Technical Details
  • Drying Times: 8 hours at 15°C to touch, 8 hours at 15°C to recoat
  • Dry Film Thickness: 200 microns
  • Theoretical Coverage: 5m2 per litre
  • VOC: Zero
  • Pot Life: 20 minutes at 15°C
  • Colour: Clear
  • Available in 4.5 Litres

The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.

Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.

Recommended products to use