Bradite Chlorinated Rubber CG23 / CC24

SKU id18094 UN1263 (Class: 3, Pk Grp: III)
Quick drying coating with excellent water and good chemical resistance. Ideal for use on swimming pools.
Available in 5 Litres
£72.00 (£86.40 Inc VAT)
*These colours are for guidance only. Variations between output devices can misrepresent the appearance of an actual colour. Also, we strongly advise that you order your complete paint requirements simultaneously to ensure a uniform batch colour.
£72.00 (£86.40 Inc VAT)

Product Description

Bradite Chlorinated Rubber is a high performance single pack chlorinated rubber Gloss / Eggshell finish with excellent chemical & water resistance.

Best Uses

Bradite Chlorinated Rubber is for ferrous, non-ferrous, concrete such as swimming pools and other absorbent mineral substrates which are dry, free of contamination, dust, efflorescence laitance and have been properly prepared. Compatibility with existing coatings should be confirmed by preparing and painting a test patch. Note: This is unsuitable for epoxy tar & bitumen paints, Portland cement, marble & tiled surfaces.

Bradite Chlorinated Rubber is ideal for milking parlours and other areas subject to chemical exposure and regular cleaning.

Application

Application and use should always conform to the codes of practice described in BS 6150 and BS 5493.

When painting new concrete it is vital to ensure the substrate is fully cured and free of laitance. Power floated, shiny or unpainted non porous concrete should be thoroughly vacuum blast cleaned to a roughness profile of 30-50 microns, or acid etched using Bradite TA37. High pressure water cleaning to remove all loose and flaking paint and contamination back to a sound substrate. For best performance, complete vacuum blast cleaning of the substrate is recommended. Bradite TD39 industrial strength detergent washing and rinsing should be used with scrubbing to remove grease or oil. Intact areas of existing coatings should be roughened by abrasive manual or disc rubbing and feathered back to a sound coating edge. Cracks and pits should be filled using a suitable screed or mortar before painting.

Galvanised steel, aluminium and other non-ferrous metal substrates should be roughened by mechanical abrading or sweep blasting with inert grit. Steel should be blast cleaned to SIS-Sa 2½ minimum, blast profile 35-50 microns and surface free of soluble salts, or de-rusted manually or mechanically to SIS-St 3 minimum.

For full painting details on Concrete Swimming Pools, and Industrial New Build and Maintenance, please see the product data sheet or contact our Technical Team for further advice.

Recommended Products To Use


Bradite Acid Etch TA37

Bradite Acid Etch TA37

Pre-treatment for power floated, non porous or very smooth concrete floors.

£22.49 (£26.99 Inc VAT)
Bradite Industrial Degreaser TD39

Bradite Industrial Degreaser TD39

Industrial degreaser for oily or soiled surfaces.

£11.38 (£13.66 Inc VAT)
Bradite Thinner TC32

Bradite Thinner TC32

Aromatic solvent for thinning alkyd based paints and equipment cleaning from Bradite.

£15.16 (£18.19 Inc VAT)