Bradite Chlorinated Rubber Primer CP26 is a high performance single pack chlorinated rubber anti-corrosive primer with excellent chemical & water resistance. A quick drying anti-corrosive paint with excellent water and good chemical resistance, for use on suitably prepared ferrous surfaces.
Bradite Chlorinated Rubber Primer CP26 is best used on ferrous substrates which are dry, free of contamination, dust, efflorescence laitance and have been properly prepared. Compatibility with existing coatings should be confirmed by preparing and painting a test patch.
Please note Bradite CR Primer CP26 is unsuitable for epoxy tar & bitumen painted surfaces.
Substrate should be dust free and completely dry before coating. High pressure water cleaning to remove all loose and flaking paint and contamination back to a sound
substrate. For best performance, complete vacuum blast cleaning of the substrate is recommended. Bradite TD39 industrial strength detergent washing and rinsing should be used with scrubbing to remove grease or oil.
Intact areas of existing coatings should be roughened by abrasive manual or disc rubbing and feathered back to a sound coating edge. Cracks and pits should be filled using a suitable screed or mortar before painting.
Steel should be blast cleaned to SIS-Sa 2½ minimum, blast profile 35-50 microns and surface free of soluble salts, or de-rusted manually or mechanically to SIS-St 3 minimum.
Painting System – Industrial New Build & Maintenance
1st coat Bradite Chlorinated Rubber Eggshell CP26
2nd coat Bradite Chlorinated Rubber Eggshell CC24
3rd coat Bradite Chlorinated Rubber Eggshell CC24*
* For a gloss finish, substitute final coat with Bradite Chlorinated Rubber Gloss CG23
Certificates & Approvals
- Manufactured under the auspices of an ISO 9001:2008 quality & ISO 14001:2004 environmental management systems
- For galvanised steel and other non-ferrous surfaces, the first coat should be substituted with Bradite Barrier Primer EU96.
- For maintenance, the first coat will be spot priming exposed substrate only.
|Stock Colours:||Light Grey|
|Tintable:||Yes. Limited colours. Please note, bespoke tints are non refundable / exchangeable|
|VOC Content:||525 g/L|
|Suitable Substrates:||Steel, blast cleaned to SIS – Sa 21/2 minimum, or mechanically prepared to SIS – St 3. Previous suitable coat dry, clean and abraded as necessary.|
|Application Method:||Brush, Roller & Spray|
|Theoretical Coverage:||10 m2/L/coat|
|Wet Film Thickness (WFT):||100 microns/coat|
|Dry Film Thickness (DFT):||40 microns/coat|
|Surface Dry:||30 minutes at 20°C|
|Overcoatable:||After minimum 8 hours at 20°C|
|Fully Cured:||6 days at 20°C|
|Cleaner / Thinner:||Bradite Thinner TC32|
|Shelf Life:||12 months minimum in original unopened containers|
|Packaging:||Available in 4.7 Litres|
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.