Bradite Cladit + Gloss PG77

SKU id18815 UN1263 (Class: 3, Pk Grp: III)
A high performance two pack polyurethane solvent based finish.
Available in 5 Litres
£85.00 (£102.00 Inc VAT)
*These colours are for guidance only. Variations between output devices can misrepresent the appearance of an actual colour. Also, we strongly advise that you order your complete paint requirements simultaneously to ensure a uniform batch colour.
£85.00 (£102.00 Inc VAT)

Product Description

Bradite Cladit Plus Gloss is a two pack polyurethane high build acrylic finish and coating. It produces a tough, hard wearing coating that is recoatable even after long periods of exposure, for long lasting protection of exterior elevations on buildings and structures.

Best Uses

Cladit + is best used on internal & external steel & non-ferrous substrates which are dry, free of contamination and have been properly prepared and primed. It can also be applied to wood, fibreglass, concrete and other mineral surfaces that are properly prepared and free of contamination, dust and efflorescence. Compatibility with existing coatings should be confirmed by preparing and painting a test patch.

Note: this is not suitable for applying over asphalt, bitumen, epoxy tar, alkyd, chlorinated rubber or vinyl based paints. Please contact our Technical Team for advice on these.

Application

Application and use should always conform to the codes of practice described in BS 6150 and BS 5493. Correct preparation is vital to ensure you obtain the full benefit from Bradite Cladit Coatings.

  • Thoroughly degrease using Bradite TD39 diluted with up to 9 parts water, rinse with clean water and allow to dry. This procedure should be carried out in conjunction with jet washing equipment at a pressure of no less than 1500psi and in such a way as not only to clean the surface but also to remove any loose and flaking material.
  • Ensure that the existing cladding coating itself is well adhered to the substrate (carry out a series of adhesion tests if necessary). Scrape failed areas to a firm edge, making sure all edges are feathered.
  • Spot prime any areas of exposed non-ferrous metal using two coats of correct Bradite primer.
  • In extreme cases the non-ferrous coating itself may have broken down exposing the underlying steel substrate. Any such areas should be manually or mechanically prepared to clean bright metal (SIS St3) and spot primed using correct Bradite primer.
  • Do not paint in adverse conditions. Temperature should be a minimum of 3°C above the dew point during application and cure. Rain on the surface shortly after application can affect the final appearance.
  • Avoid painting in areas exposed to direct sunlight as this may accelerate drying and make application difficult.

Recommended Products To Use


Bradite Industrial Degreaser TD39

Bradite Industrial Degreaser TD39

Industrial degreaser for oily or soiled surfaces.

£11.38 (£13.66 Inc VAT)
Bradite Thinner TP33

Bradite Thinner TP33

For thinning Bradite two pack polyurethane paints and equipment cleaning.

£20.00 (£24.00 Inc VAT)