Bradite Cladit + Semi Gloss PC76

SKU id18825 UN1263 (Class: 3, Pk Grp: III)
For the long lasting protection of exterior elevations on buildings and structures.
Available in 5 Litres
£85.00 (£102.00 Inc VAT)
*These colours are for guidance only. Variations between output devices can misrepresent the appearance of an actual colour. Also, we strongly advise that you order your complete paint requirements simultaneously to ensure a uniform batch colour.
£85.00 (£102.00 Inc VAT)

Product Description

Bradite Cladit plus Semi-Gloss is a two pack polyurethane high build acrylic finish and coating. It produces a tough, hard wearing coating that is recoatable even after long periods of exposure, for long lasting protection of exterior elevations on buildings and structures.

Best Uses

Bradite Cladit + Semi Gloss is best used on exterior cladding requiring a hard wearing, flexible, weather and light resistant coating. It has excellent adhesion to existing cladding coatings (coil, plastisol and powder coatings) with minimal preparation.

Suitable for use over most existing cleaned and prepared cladding coating systems. Compatibility with existing coatings should be confirmed by preparing and painting a test patch. Bare steel and non-ferrous metals should be properly prepared and primed before painting with this product.

Application

Always aim to paint an elevation preceding direct sunlight illumination to prevent painting onto warm surfaces which may cause too rapid drying and detract from application properties and finish appearance quality. Application and use should always conform to the codes of practice described in BS 6150 and BS5493.

High pressure water cleaning to remove all loose and flaking paint and contamination back to a sound substrate. Bradite TD39 industrial strength detergent washing and rinsing should be used with scrubbing to remove grease or oil. Check & confirm adhesion of apparently sound cladding coating by carrying out cross hatch adhesion test to all elevations. If adhesion is suspect then elevation should be completely stripped of old coating and repainted.

Intact areas of existing coatings should, ideally, be roughened by manual or mechanical sanding. Feather back exposed areas to a sound coating edge. Cracks and pits should be filled using a suitable filler before painting. Substrate should be dust free and completely dry before coating.

Exposed ferrous substrate should be blast cleaned to SIS Sa21/2 or manually cleaned to SIS St3, then patch primed with Bradite Surface Tolerant Epoxy Primer EP92*.

Recommended Products To Use


Bradite Thinner TP33

Bradite Thinner TP33

For thinning Bradite two pack polyurethane paints and equipment cleaning.

£20.00 (£24.00 Inc VAT)
Bradite Cladit + Gloss PG77

Bradite Cladit + Gloss PG77

A high performance two pack polyurethane solvent based finish.

£85.00 (£102.00 Inc VAT)
Bradite Epoxy Barrier Primer EU96

Bradite Epoxy Barrier Primer EU96

For internal & external steel & non-ferrous substrates

£68.89 (£82.67 Inc VAT)
Bradite Surface Tolerant Primer EP92

Bradite Surface Tolerant Primer EP92

A high performance two pack epoxy solvent based surface tolerant anticorrosive primer.

£65.00 (£78.00 Inc VAT)