Centrecoat Flexicoat Masonry Paint

SKU id20807 UN1263 (Class: 3, Pk Grp: III)
An external water based smooth, premium masonry paint with added P.T.F.E.
Available in 5 and 10 Litres
£47.00 (£56.40 Inc VAT)
*These colours are for guidance only. Variations between output devices can misrepresent the appearance of an actual colour. Also, we strongly advise that you order your complete paint requirements simultaneously to ensure a uniform batch colour.
£47.00 (£56.40 Inc VAT)

Product Description

Centrecoat Flexicoat is an external water based smooth, premium masonry paint with added P.T.F.E. Utilises increased flexibility & dirt resistance to help protect against harsh weather conditions & increased dirt pollution.

Best Uses

Centrecoat Flexicoat utilises a tough acrylic binder system to give a durable hard wearing matt finish with superb opacity giving great depth of colour. For exterior application to brick, cement and plaster as a smooth premium masonry paint.

Application

Apply using brush, roller, HVLP or airless spray. All surfaces to be coated must be clean, dry and free from any contaminants including dirt, algae, grease and loose or flaky paint. Loose or flaky paint can occur after painting has begun if painting over previous weak paint layers, to avoid this sand back any weak paint layers before painting commences.

If repairs are needed to be made use fillers of same porosity and density as main substrate, this will help achieve a uniform finish and reduce any chance of visible differences in colour or tone. Follow manufacturers instructions regarding application guides and drying times. If the wall/floor to be painted is uneven or highly porous then a priming/mist coat may need to be applied. Apply a priming/mist coat by diluting with approximately 10% of clean water by weight.

It is important to note that highly porous surfaces that are not properly prepared can cause difficulties during application and may lead to an uneven colour finish.

If using more than one tin, check that the batch numbers of each tin match, if batch numbers vary ensure you intermix tins before use. Ensure to stir all tins thoroughly before use. Before full application paint out a small test patch and allow to dry to ensure colour satisfaction. Apply only when temperatures are above 5ºC, failure to observe minimum temperature will result in poor film formation and poor adhesion.