Coo-Var Anti Slip Acrylic Floor Paint is a durable, water based floor paint to provide a durable and hard wearing surface with an anti-slip finish. Suitable for concrete, wood, tarmac, stone & brickwork.
Coo-Var Anti-Slip Acrylic Floor Paint can be used on concrete, wood, tarmac, stone, brickwork and suitably prepared metal. Ideal to provide an anti slip finish to warehouses, ramps, parking areas, fire exits etc.
This product has been independently tested and has a PTV rating of 68 in dry conditions and 58 in wet. UK standards recommend a minimum Pendulum Test Value on floors of 36 dry, wet or contaminated. Suitable for indoor and outdoor use.
All surfaces should be clean, dry, sound and free from contaminants.
Concrete - power floated, granolithic and smooth surfaces should be roughened first to provide a good "key" for the paint. This can be done mechanically by abrading or blasting, or chemically, using Coo-Var Acid Etch. These processes will have the advantage in addition to preparing the surface of also removing dirt and laitance. New concrete must be allowed to cure thoroughly which can take up to 3 months. Other surfaces have to be prepared and primed with the suitable primer for that substrate.
Existing painted surfaces - Surfaces should be cleaned, degreased and sanded to ensure an adequate "key" is produced. Remove all loose and flaking material and treat bare areas as new substrate and prepare accordingly.Apply using brush or roller.
Mix well before use. Apply direct to wood, Coo-Var All Metals Primer on Metal, Coo-Var Anti-Slip Acrylic Floor Paint thinned 5% with clean water on all other unpainted surfaces.
Certificates & Approvals
This product has been independently tested and has a PTV rating of 68 in dry conditions and 58 in wet. UK law recommends on a minimum Pendulum Test
Value on floors of 36 dry, wet or contaminated. Suitable for indoor and outdoor use.
|Stock Colours:||Tile Red, Grey, Light Grey, Yellow, Green, Black and White|
|Tintable:||Yes - 5 litre minimum. Please note, bespoke tints are non refundable / exchangeable|
|VOC Content:||41 g/Litre|
|Volume Solids:||34 to 36%|
|Suitable Substrates:||Concrete, wood, tarmac, stone, brickwork and suitably prepared metal|
|Application Method:||Brush or Roller|
|Theoretical Coverage:||5 to 9 sq.m / litre @ 35 microns DFT|
|Wet Film Thickness (WFT):||100 to 110 microns|
|Dry Film Thickness (DFT):||35 to 40 microns|
|Touch Dry:||1 hour at 20°C|
|Hard Dry:||4 hours at 20°C|
|Overcoatable:||After 6 hours minimum at 20°C|
|Fully Cured:||5 to 7 days at 20°C|
|Cleaner / Thinner:||Thin with Clean Water (Max vol 10%)|
|Packaging:||Available in 2.5 and 5 Litres|
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.