Coo-Var GP101 Graffiti & Flyposting Protection

SKU
ID20427
UN1263 (Class: 3, Pk Grp: III)
A clear surface coating, available in a matt and gloss finish, offering excellent protection against graffiti and poster vandalism.
Available in 2.5 and 5 Litres in Clear
From £158.74 £132.28
In stock
Only %1 left
Product Description

Coo-Var GP101 Graffiti & Flyposting Protection is a clear surface coating, available in a matt and gloss finish, offering excellent protection against graffiti and poster vandalism.

Best Uses

Coo-Var GP101 Graffiti & Fly Posting Protection System can be used on a wide range of clean prepared rough or smooth surfaces, whilst continuing to retain the appearance and aesthetics of the original surface. This product is also formulated to prevent permanent marking by graffiti, which can easily be cleaned using water or mild cleansing agents.

GP101 also makes Fly Posters easy to remove. Posters just peel off and graffiti can be removed quickly and easily with water or water with mild detergent.

Application

Remove existing graffiti with dedicated graffiti removal agents when required. Ensure that the substrate is free of any residue from graffiti removal agents. The surface must be clean, sound and free of any dust, dirt, oil and grease. If necessary, wash substrate with high pressure water and allow to dry.

Adhesion should be checked over all surfaces as follows to ensure suitability of GP101: -
Dab GP101 with a small rag onto a small area of substrate (5-10cm² is sufficient) and allow to dry overnight. For signage and murals, after sufficient dry time has elapsed, rub firmly across the test area with finger for loss of adhesion.

For other painted surfaces, rub firmly with a rag soaked with Thinners 14, then rub the surface by hand. If there is no evidence of GP101 peeling off the surface is compatible.

Stir well before use and use manageable quantities; Pour a small quantity into roller tray or spray unit as required. Then reseal container immediately. GP101 has a pot life of approximately two hours when exposed to the elements, can vary depending on the ambient conditions.

Technical Details
Components: One Part
Type: Solvent Based
Finish: Matt or Gloss
Stock Colours: Clear
Tintable: No
VOC Content: 500.0g per Litre
Volume Solids: 53.7%
Suitable Substrates: For a wide range of clean prepared rough or smooth surfaces
Application Method: Brush, Roller or Spray
Theoretical Coverage: 8 - 10 m2 per litre at microns
Wet Film Thickness (WFT): 100 microns
Dry Film Thickness (DFT): 55 microns
Induction Time: -
Pot Life: 20 hours at 20°C
Touch Dry: 1 - 2 hours at 20°C
Overcoatable:
Fully Cured:
Cleaner / Thinner: Thinners 14
Shelf Life:
Packaging: Available in 2.5 and 5 Litres

Related Products