Hempel Hempadur 15553 Primer

SKU
ID21153
Part A and B: UN1263 (Class: 3, Pk Grp: III)
A two-component epoxy paint, that cures to a flexible, well adhering coating with good abrasion and impact resistance.
Available in 5 and 20 Litres
From £59.87 £49.89
In stock
Only %1 left
Product Description

Hempel Hempadur 15553 Primer is a two-component epoxy paint. It cures to a flexible, well adhering coating with good abrasion and impact resistance. Contains zinc phosphate. Cures down to -10°C/14°F.

Best Uses

Hempel Hempadur 15553 is ideal as a primer for systems on hot dipped galvanized, aluminium and stainless steel surfaces in moderately to severely corrosive environments. Hempel Hempadur 15553 is also suited when roughening of the surface is not possible. See data sheet for further details.

Application

Stainless steel and aluminium: Remove oil and grease etc. thoroughly with suitable detergent. Remove salts and other contaminants by high pressure fresh water cleaning. Roughening of the surface is recommended for optimum adhesion.

Galvanised steel: Remove oil and grease, etc. with suitable detergent. Remove salt and other contaminants by (high pressure) fresh water cleaning. Zinc salts (white rust) must be removed by high pressure hosing combined with rubbing with a stiff nylon brush if necessary. It is recommended to overcoat spray-metallised surfaces as soon as possible to avoid possible contamination.

Ammonium chloride or any other passivation agent should not be present on the surface when coating the galvanized surface. Water should not be used for cooling down the steel. Cleaning of steel should not be initiated unless the steel temperature is below: 30°C/86°F As the galvanized zinc layer may be porous, it is recommended to apply a mist coat of diluted product, allow air to escape, and then apply a full coat of the product a few minutes later.

Apply using airless spray or brush.

Technical Details

Approvals

  • Complies with European Fire Standard EN 13501-1; classification B-s1, d0
  • Approved as a low flame spread material when used as part of a predefined paint system
  • Complies with EU Directive 2004/42/EC: subcategory j

Technical Info

Components: Two Pack
Type: Zinc Phosphate
Finish: Flat
Stock Colours: 11320 Grey
Tintable: No
VOC Content: 387 g/L
Volume Solids: 55%
Suitable Substrates: For hot dipped galvanized, aluminium and stainless steel surfaces in moderately to severely corrosive environments
Application Method: Airless Spray, Brush
Theoretical Coverage: 11 m2 per litre at 50 microns
Wet Film Thickness (WFT): 100 microns
Dry Film Thickness (DFT): 50 microns
Induction Time: -
Pot Life: 2 hours at 20°C
Surface Dry: 20 minutes at 20°C
Overcoatable: See data sheet
Fully Cured: 7 days at 20°C
Cleaner / Thinner: Hempel Thinner 08450
Shelf Life: 6 months for BASE and 3 years for CURING AGENT (stored in closed container) (25°C/77°F) from time of production.
Shelf life is dependent on storage temperature. Shelf life is reduced at storage temperatures above 25°C/77°F. Do not store above 40°C/104°F.
Packaging: Available in 5 and 20 Litres

Related Products