Please note, this product is now discontinued. Contact our Technical Team for a suitable alternative.
Jotun Jotamastic Plus is a two component amine cured epoxy mastic coating. It is a surface tolerant, high solids, high build and specially designed for areas where optimum surface preparation is not possible or desired.
Best Uses
Jotun Jotamastic Plus provides long lasting protection in environments with high corrosivity. Formulated to be used as primer, mid-coat, finish coat or as single coat system in atmospheric and immersed environments. Suitable for properly prepared carbon steel and aged coating surfaces.
Primarily designed for maintenance and repair. For marine, it is suitable for outside hulls, exterior and interior areas. Recommended for offshore environments, including splash zones, refineries, power plants, bridges, buildings, mining equipment and general structural steel.
Jotamastic Plus is a fast drying - faster over coating interval
Compatible with a wide range of topcoats
Aluminium flakes increase corrosion protection and water resistance
Unrivalled penetration, adhesion and surface tolerance
Long lifetime expectations
Low VOC and solvent emission
Limited surface preparation - saving time
One all season curing agent 0-40°C
Jotamastic Plus is easy to apply by airless spray as well as brush and roller for difficult to reach areas
Problem free application - good film formation
Application
Prepare carbon and shop primed steel to SA 2. For coated surfaces, ensure the substrate is clean, dry and undamaged while being a compatible coating. Apply using airless spray. Brush is recommended for stripe coating and small areas. Care must be given to achieve the specified dry film thickness. Roller may be used for small areas though is not recommended for the first primer coat. Care must be taken to achieve the correct DFT.