Jotun Penguard Express is a two component, fast drying, protective epoxy coating for steel, aluminium and concrete substrates which are exposed to atmospheric corrosion.
Jotun Penguard Express is a fast drying, high solids, high build product. Being a two component amine cured epoxy coating, it is designed for new construction where a fast drying product is essential. Penguard Express can be used as a primer, mid or finish coat and can be used as a single coat system in atmospheric environments.
Jotun Penguard Express is suitable for suitably prepared carbon steel, aluminium, concrete and galvanised steel substrates. It can be applied in sub zero temperatures.
Best Uses
Jotun Penguard Express is suitable for use on structural steel and piping which is exposed to environments with high levels of corrosive destruction. It is recommended for offshore environments refineries, power plants, bridges, buildings and mining equipment.
Can be used as primer, mid-coat, finish coat or as single coat system in atmospheric environments. Suitable for properly prepared carbon steel, aluminium, concrete and galvanised steel substrates. It can be applied at sub zero surface temperatures.
Application
Recommended application is with an airless spray. A brush can be used for stripe coating and small areas. Follow application guide download for instructions.
Surfaces and Environment
Jotun Penguard Express is suitable for structural steel and piping which is exposed in environments which has high levels of atmospheric corrosion.
This product is part of the Network Rail/Railtrack RT98 Systems M20 and N1
Certificate numbers XM92/M20-140, M20-179, XN90/N1-075 and N4-102
Pre-qualification testing in accordance with NORSOK M-501, Rev. 5, System 1, suitable for exterior exposure in offshore environment, below 120 °C Tested in accordance with ISO 12944-5, C5-High environment
Low Flame Spread in accordance with EU Directive for Marine Equipment. Approved in accordance with parts 5 and 2 of Annex 1 of IMO 2010 FTP Code, or Parts 5 and 2 of Annex 1 of IMO FTPC when in compliance with IMO 2010 FTP Code Ch. 8
Technical Info
Components:
Two Part
Type:
Amine cured epoxy coating
Finish:
Matt
Stock Colours:
Grey, Grey XO, Red, Buff, Light Red
Tintable:
No
VOC Content:
264.0g per litre
Volume Solids:
74%
Suitable Substrates:
Suitable for properly prepared carbon steel, aluminium, concrete and galvanised steel substrates