KEIM Silan 100 is a water repellent that is solvent free and silane based, suitable for mineral based building materials such as concrete where carbonation resistance is required.
Keim Silan 100 is ideal where surfaces are exposed to de-icing salts and to protect reinforcing steel from chloride corrosion due to salt penetration. This product can also be used as a primer prior to top coating with Keim products or just a stand alone water repellent finish.
Keim Silan 100 should be applied as two wet on wet flood coats or as a single flood coat by brush or low pressure spray. If required within a period of up to 12 hours, and these times are critical, the first coat of Keim top coat must be applied. Ambient and substrate temperature should be between 5° and 30°C. Non absorbent surfaces cannot be treated with Keim Silan 100.
|Suitable Substrates:||Mineral building materials - especially concrete|
|Application Method:||Brush or Low Pressure Spray|
|Theoretical Coverage:||0.2lt/m2 for one coat, 0.3lt/m2 for two coats|
|Application Conditions:||Ambient and substrate temperature above 5°C and below 30°C|
|Cleaner / Thinner:||Clean tools with water immediately after use|
|Shelf Life:||Approx. 12 months, if kept cool but frost free in tightly closed containers|
|Packaging:||Available in 5 Litres|
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.