PPG Steelguard 751

PPG Steelguard 751 is a single pack thin film solvent borne intumescent coating for 120 minutes of cellulosic fire protection of structural steelwork.

Best Uses

PPG Steelguard 751 will provide up to 120 minutes protection from cellulosic fires and is suitable for both off-site or on-site application. With up to 1500 µm (60.0 mils) DFT in a single coat, this coating is suitable for C1 to C4 internal and external environments (ISO 12944); for dry internal (C1) environments no topcoat is required. Weather resistant up to 12 months without topcoat provided the coating has been applied in accordance with data sheets and is not subject to running or pooling water, high humidity or immersion conditions. Tested and assessed to EN 13381-8, BS 476-20/21 and AS 1530.4. CE marked product, ETA 15/0439. Assessed to ETAG 018-2 for all durability classifications

Application

Approved primer must be sound, dry and free from contaminants. Stir thoroughly until homogeneous and free from lumps. Apply with airless spray. Use brush or roller for touch up and repair only. Refer to data sheets for further info.

IMPORTANT INTUMESCENT PRODUCT NOTE: Always contact Promain’s technical team prior to purchase to obtain a tailored project specification and the advice necessary. The information displayed on this website should only be used as a guide. Promain UK Limited will not be held liable for any resulting damage to property, human life or monetary costs incurred due to incorrect specification, preparation, application or maintenance that has occurred due to negligence by either the purchaser or applicator. This includes your failure to have contacted us to obtain the relevant advice/specification.