£7.75 delivery on orders excluding certain products & postcodes *
Please note, this product has a minimum order quantity of 2 x 15 Kg bags.
Remmers Restoration Mortar is used for restoring, supplementing and re-profiling mineral substrates such as natural stone, brick, concrete and synthetic stone. It can also be used to reproduce ornamental building elements in a tamping procedure.
Its physical characteristics correspond to the requirement for the lowest possible inherent stress and physical-mechanical properties that are coordinated to the natural stone substrate (compressive and bonding strength, water transport, etc.).
A general prerequisite for working with Remmers Restoration Mortar is a load-bearing substrate (balanced strength profile). This can be achieved by preparing the stone with a stone mason's tools or by consolidating the stone and, if necessary, by combining treatment with Remmers Antihygro.
Preliminary restoration work
For valuable heritage surfaces that would lose their surface characteristics if the substrate were prepared using stone mason's tools, the substrate can be prepared by consolidating the stone with the Remmers Silicic Acid Ester System. The exact procedure for this must be determined for the specific object.
Preparation with stone mason's tools
The areas to be restored with Restoration Mortar should be cut out at an appropriate angle with a chisel or fly-wheel cutter. The damaged, weathered areas should be scabbled out down to sound stone. Edge areas should not taper off to zero if possible. Supporting reinforcement in the form of plastic star dowels or stainless steel should only be used on strongly cantilevered elements such as cornices, etc. These are anchored with plastic dowels or thickened Remmers Epoxy BH 100.
Components: | Single Pack |
Type: | Dry Mortar |
Finish: | - |
Stock Colours: | Medium Grey, Off-white, Yellow Ochre, Red Brown, Beige, Brick Orange, Anthracite and others |
Tintable: | Yes - Please call for further information. Please note, bespoke tints are non refundable / exchangeable |
VOC Content: | - |
Volume Solids: | - |
Suitable Substrates: | Natural Stone, Brick, Concrete & Synthetic Stone |
Application Method: | Mortar Cover, Filling Knife or Trowel |
Theoretical Coverage: | Standard Colours approx. 1.8 kg/l void |
Wet Film Thickness (WFT): | - |
Dry Film Thickness (DFT): | - |
Induction Time: | - |
Working Temperature: | Between +5°C and +25°C |
Touch Dry: | - |
Overcoatable: | - |
Fully Cured: | After 3-4 weeks at 20°C |
Cleaner / Thinner: | Clean tools with water whilst material is still wet |
Shelf Life: | 12 months stored dry in closed bags |
Packaging: | Available in 15 Kg bags |