Rustoleum Galva Expresse 2180 is a very fast drying zinc rich primer based on a styrene-acrylic resin. The product contains pure zinc as pigment and provides excellent protection against corrosion.
Rustoleum Galva Expresse 2180 should be used on new, bare steel or galvanised steel surfaces. This product is intended to be applied on small areas or for touch up. 2180 can be recoated with non saponifiable coatings. Suitable as a primer or as a single coat in light industrial exposures, corrosive environments and high humidity areas.
Remove dirt, grease, oil, loose rust and all other surface contaminants by appropriate means. The surface must be clean and dry during application. Remove Rustoleum Galva Expresse 2180 cover cap. Shake vigorously for at least one minute after the rattle of mixing ball is heard. Shake frequently during use. Hold can approx. 25 cm from surface. Use back and forth motion keeping can parallel with surface. Ensure that can is in motion when spray button is pressed to avoid runs and sags. Apply a full, wet coat to achieve a close, dense coating film, avoid dry spray. After use turn can upside down and press spray button for 2 - 3 seconds to clean valve.
- Heat Resistant: 350C (dry heat)
|Components:||6 x 500ml Aerosols|
|VOC Content:||645 g/l|
|Suitable Substrates:||New, Bare Steel or Galvanised Steel|
|Theoretical Coverage:||1.4 m² per spray can at 35 μm dry|
|Wet Film Thickness (WFT):||100 μm|
|Dry Film Thickness (DFT):||35 μm|
|Touch Dry:||5 minutes at 20°C|
|Overcoatable:||After 48 hours at 20°C|
|Fully Cured:||3 days at 20°C|
|Cleaner / Thinner:||-|
|Shelf Life:||3 years from date of production unopened|
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.