Sherwin Williams Heat-Flex Hi-Temp 1200 is the next generation single component inert multipolymeric matrix coating that outperforms alternatives in combating corrosion under insulation (CUI) and in high heat applications.
Recommended uses include applying direct to steel or stainless steel, as a coating under insulation, for cyclic service up to 649°C, acceptable for use on cryogenic equipment, for use over properly prepared steel surfaces, either insulated or uninsulated. Areas of application include: Power Plants, Refineries, Chemical Facilities, Offshore/Marine, Pulp and Paper. Benefits include: Resists corrosion under insulation, Resists stress corrosion cracking, Application surface temperatures from ambient to 260°C, Operating surface temperatures cryogenic to 649°C, Heat curing not required to cure and provide corrosion resistance, Self priming, single component, No maximum recoat time.
Prepare stainless steel or carbon steel to SSPC-SP10. Surface must be clean, dry, and in sound condition. Remove all oil, dust, grease, dirt, loose rust, and other foreign material to ensure adequate adhesion. When using spray application, use a 50% overlap with each pass of the gun to avoid holidays, bare areas, and pinholes. If necessary, cross spray at a right angle. See data sheets for in depth info.
- Finish: Low Sheen
- Dry Film Thickness: 57 -142 microns
- Theoretical Coverage: 4.5 - 3.7 microns
- Drying Times: 20 minutes to touch at 25°C, 1 hour at 25°C to recoat
- Available in Grey and Dark Grey
- Available in 18.9 Litres
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.