Sherwin Williams Epo-Phen FF is a flake filled MIO amine cured epoxy phenolic novolac formulated for use under thermal insulation at elevated or cryogenic temperatures and for immersion service in water and hydrocarbons such as gasoline, fuel oil, and diesel fuel.
Sherwin Williams Epo-Phen FF benefits from being temperature resistant to 218°C constant; 232°C intermittent (dry service), self priming, and chemical resistant. The micaceous iron oxide (MIO) provides: High temperature resistance, Film reinforcement, One coat, high build application, Improved edge protection.
Recommended for use on steel and stainless steel tanks and piping under insulation, non-insulated structural steel and piping subjected to chemical or abrasion attack, use in areas subject to wet/dry cycling up to 149°C, use in areas where temperature resistance up to 232°C is required (dry service). Acceptable for use in immersion service at elevated temperatures for fresh water and distilled water 99°C.
Suitable for storage of gasoline, fuel oil, diesel fuel, and other similar hydrocarbon cargos. Not qualified for potable water immersion. Suitable for water and waste water facilities, and wind tower gearbox lining.
Prepare steel to Sa2½ ISO8501-1:2007 Average surface profile 50-75 microns. Surface must be clean, dry, and in sound condition. Remove all oil, dust, grease, dirt, loose rust, and other foreign material to ensure adequate adhesion.
For non-immersion service, Epo-Phen may be top coated with Acrolon 218 HS up to 93°C or with Heat-Flex 450 up to 232°C.
- Finish: Semi Gloss
- Dry Film Thickness: 175 - 225 microns
- Pot Life: 2 hours at 25°C
- Theorectical Coverage: 3.9m2 per litre for 175 microns, 3,0m2 per litre for 225 microns
- Available in Grey
- Available in 5 and 20 Litres
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.