£7.75 delivery on orders excluding certain products & postcodes *
Sherwin Williams Macropoxy 646 is best used as a primer finish for marine applications, pulp and paper mills, refineries, power plants, chemical plants, offshore platforms, tank exteriors, nuclear power plants, and water treatment plants. White colour is acceptable for immersion use for salt water and fresh water. Suitable for application to concrete floors.
Not acceptable for potable water. Tinting is not recommended for immersion service.
Prepare steel substrate to SSPC-SP10/NACE 2/Sa2½. Surface must be clean, dry, and in sound condition. Remove all oil, dust, grease, dirt, loose rust, and other foreign material to ensure adequate adhesion. Stripe coat all crevices, welds, and sharp angles to prevent early failure in these areas.
When using spray application, use a 50% overlap with each pass of the gun to avoid holidays, bare areas, and pinholes. If necessary, cross spray at a right angle. Spreading rates are calculated on volume solids and do not include an application loss factor due to surface profile, roughness or porosity of the surface, skill and technique of the applicator, method of application, various surface irregularities, material lost during mixing, spillage, over thinning, climatic conditions, and excessive film build.
Excessive thinning of material can affect film build, appearance, and adhesion. Do not mix previously mixed material with new. Do not apply the material beyond recommended pot life.
Components: | Two Pack |
Type: | Epoxy Primer Finish |
Finish: | Semi-Gloss |
Stock Colours: | White |
Tintable: | Yes. Please note, bespoke tints are non refundable / exchangeable |
VOC Content: | Unthinned: <250 g/ltr Thinned 10%: <300 g/ltr |
Volume Solids: | 72% ± 2%, |
Suitable Substrates: | Steel |
Application Method: | Brush, Roller, Airless Spray, Conventional Spray, or Plural Component Spray |
Theoretical Coverage: | Min: 5.76 m2/ltr, Max: 2.88 m2/ltr |
Wet Film Thickness (WFT): | Min: 175 Microns, Max: 347 microns |
Dry Film Thickness (DFT): | Min: 125 microns, Max: 250 microns |
Induction Time: | 30 minutes at 25°C |
Pot Life: | 4 hours at 25°C |
Touch Dry: | 2 hours at 25°C |
Overcoatable: | Min: 8 hours at 25°C, Max: 1 Year at 25°C |
To Cure - Service: | 7 days at 25°C |
To Cure - Immersion: | 7 days at 25°C |
Cleaner / Thinner: | C50 |
Shelf Life: | 36 months from date of production unopened or 'use by' date where specified |
Packaging: | Available in 5 Litres. Telegrey RAL 7047 is only available in 20 Litres |