Sherwin Williams Transgard TG115 - Formerly Leighs is a high build aluminium epoxy maintenance primer for abraded surfaces.
Sherwin Williams Transgard TG115 is best suited for brush application onto hand or mechanically prepared surfaces giving excellent wetting and adhesion characteristics. Suitable for atmospherically exposed surfaces but not recommended for exposure to severe chemical environments. May be spray applied to blast cleaned surfaces. Recommended curing temperature above 10°C. Extended drying times will be observed at lower temperatures. Macropoxy M902 is recommended alternative for low temperature application and curing.
Recommended application via brush or airless spray onto blast cleaned surfaces. Recommended cleanser / thinner no5 for thinning, no9 or no13 for cleaning. Recommended undercoat Transgard TG116. For overcoating with epoxy products (including self overcoating), the maximum recommended interval is 28 days at 23°C. Blast clean to Sa2½ BS EN ISO8501-1:2007. Average surface profile in the range 50-75 microns. Manually prepared surfaces should be prepared to a minimum standard of ST3 BS EN ISO8501-1:2007 at the time of coating. Ensure surface to be coated are clean, dry and free from all surface contamination. Compatibility - This product is fully compatible with Epigrip M902 ( Item 115 low temperature curing grade ) and the two products may be interchanged within any specification requiring the use of Item 115, depending upon the application conditions.
- Highways Agency Item No.115
- Drying Times: 6 hours at 15°C to touch, 16 hours at 15°C to recoat
- Dry Film Thickness: 100 microns
- Theoretical Coverage: 7.5m2 per litre
- Pot Life: 3 hours at 15°C
- Available Colour: Aluminium
- Available in 5 Litres
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.