Teamac Q113 2 Pack Zinc Phosphate Primer

Teamac 2 Pack Zinc Phosphate Primer is a two pack epoxy anti-corrosive primer for application to steel which is clean and free from scale and / or rust.

Best Uses

Teamac 2 Pack Zinc Phosphate Primer is suitable for marine, agricultural, construction equipment / plant and machinery as an anti-corrosive primer.

Teamac 2 Pack Zinc Phosphate Primer is used for application to blast cleaned and other suitably prepared steel surfaces. It is not suitable for use as a weld through blast primer. Provided the steel has been cleaned effectively, an outstanding bond is formed between primer and metal.

Application

Ensure all surfaces are clean, dry and free from grease, oil and any other contaminates. Bare steel should be free from dust, rust and scale. Blast cleaning to SA 2½ is recommended. If blast cleaning is impractical, mechanical cleaning should be employed, as hand cleaning does not clean the steel to the required degree. Any oil or grease should be removed with solvent before de-rusting. Where blast cleaning is carried out after assembly, special attention must be paid to edges, corners, nuts, bolts welds, etc. Welds should, if necessary, be ground and all weld spatter, slag etc. must be removed.

By volume, mix 3 parts of the base with 1 part of the activator, as the ratio supplied. These should be thoroughly mixed together, preferably by a slow speed electric mixer. Ensuring the material is thoroughly mixed is very important - poorly mixed product can lead to soft spots and uncured coatings. Thinning is not normally required for airless spray systems. Use within 4 hours. Clean and flush equipment immediately after use to prevent the paint solidifying in guns, pots and lines.

Can be applied over 2 pack zinc phosphate blast primers which are free from contamination.