Jotun Tankguard HB Classic Formerly Tankguard HB

SKU
ID17002
Part A: UN1263 (Class: 3, Pk Grp: III), Part B: UN2734 (Class: 3.8, Pk Grp: II)
A 2 part polyamine cured epoxy coating with good chemical resistance formulated for use as a primer, mid coat or finish coat.
Available in 20 Litres
From £344.88 £287.40
In stock
Only %1 left
Product Description

Jotun Tankguard HB Classic is a two part polyamine cured epoxy coating with good chemical resistance formulated for use as a primer, mid coat or finish coat in atmospheric and immersed environments on prepared steel and concrete surfaces. Formerly Tankgaurd HB.

Best Uses

Jotun Tankguard HB is Suitable for properly prepared carbon steel, galvanised steel, stainless steel and concrete substrates. Designed as an internal tank coating for chemical tanks. This coating has good resistance to a wide range of products. Can be used as a coating for grey water, drilling mud, brine and crude oil tanks. Also recommended as a protective coating for the internal lining for offshore, onshore and buried tanks and pipes.

  • Federal Drug Authority, USA, FDA Title 21, Part 175.300, approved for exposure to dry and liquid foods

Application

To secure lasting adhesion to the subsequent product all surfaces shall be clean, dry and free from any contamination. Optimum performance, including adhesion, corrosion protection, heat resistance and chemical resistance is achieved with recommended surface preparation.

Prepare as per data sheet. Apply using airless spray. Use a brush for stripe coating. Use a roller for scallops, ratholes, small pipes etc.

Technical Details

Approvals

  • Federal Drug Authority, USA, FDA Title 21, Part 175.300, approved for exposure to dry and liquid foods
  • Norsok M-501 System 3E

Technical Info

Components: Two Part
Type: Polyamine cured epoxy coating
Finish: Matt
Stock Colours: Pink, Grey
Tintable: No
VOC Content: 405.0g per litre
Volume Solids: 65%
Suitable Substrates: Suitable for properly prepared carbon steel, galvanised steel, stainless steel and concrete substrates.
Application Method: Airless Spray, Brush or Roller
Theoretical Coverage: 8.1 - 4.1m2 per litre
Wet Film Thickness (WFT): 125 - 245 microns
Dry Film Thickness (DFT): 80 - 160 microns
Induction Time: 10 mins at 23°C
Pot Life: 2 hours at 23°C
Touch Dry: 8 hours at 10°C
Overcoatable: 12 hours at 10°C
Fully Cured: 13 days for service, 6 days for immersion at 10°C
Cleaner / Thinner: Jotun Thinner No. 23
Shelf Life: 24 months
Packaging: Available in 20 Litres

Related Products