£7.75 delivery on orders excluding certain products & postcodes *
Promain UK Limited offer a vast range of metal primers suitable for application to all types of metal surfaces.These metal primers will help prepare the material before painting as well as ensuring that there will be a better adhesion for the paint when applied to the surface. Primers also increase the durability of the paint as well providing the metal with an extra layer of protection. The range of metal primers that we have at Promain are available so that we can be sure that you are getting the very best primer depending on the surface that you are painting. Promain supply metal primers that come in a range of application methods, whether this is applied with a brush, roller, airless spray or an aerosol paint we have the perfect application method for you depending on your requirements.
A two pack corrosion resistant metal primer formulated as a weldable pre-construction primer or field or shop applied primer.
A self-priming pure epoxy paint which cures to a corrosion resistant coating.
A two pack epoxy primer/finish offering corrosion protection in one coat.
Provides rapid cure and overcoating even under low temperature conditions.
A one pack alkyd primer containing zinc phosphate anti-corrosive pigment.
A fast drying, rapid recoat, metallic zinc-rich epoxy primer. Replacement for Interzinc 52.
A two component primer which is ideal for speeding up production and throughput.
An epoxy primer which provides optimised control where thin film application is required.
A fast curing epoxy primer for use with International 3200 product series.
A pure epoxy primer with anti-corrosive properties and overcoating intervals of up to 6 months.
A water-based coating that provides superior adhesion and corrosion protection for metal cladding.
A two component, high solids polyamine adduct cured zinc rich epoxy primer. Meets Norsok M-501 Rev. 6, System 1.
A two component epoxy zinc phosphate / micaceous iron oxide primer suitable for low temperature overcoating.
A two component, low VOC, high solids, fast curing epoxy primer / finish containing zinc phosphate anti-corrosive pigmentation.
Formerly Amercoat 139. A two component polyamide cured epoxy prefabrication primer.
A grey, two component, moisture curing, low zinc silicate prefabrication primer suitable for automatic application on shot blasted steel plates.
A two-component, activated zinc epoxy primer in compliance with the requirements for Level 3, type II in SSPC Paint 20, 2002.
A two pack blast primer for Sherwin Williams Firetex intumescent coatings.
A two component moisture curing, low zinc, silicate prefabrication primer, suitable for application on shot blasted steel plates.
A 2 pack epoxy zinc rich anti corrosive primer for the protection of blast cleaned steel.
Cold Galvanising zinc paint for cathodic anti corrosion metal protection and rust resistance.
A two component polyamide-cured epoxy tiecoat for a wide range of topcoats for immersion and non-immersion service.
A two component, metallic zinc primer for steel in aggressive environments.
A two component epoxy anti-corrosive primer pigmented with zinc phosphate for anti corrosive protection.
A high build polyamide low temperature tintable zinc phosphate epoxy shop primer/coating for atmospheric conditions.
A two pack, heat resistant, zinc silicate shop (pre-construction) primer providing good corrosion protection (even after heating up to 800°C).