Please note, this product is now discontinued. Please see PPG Amerlock 2 as a potential alternative.
PPG Amerlock 2C is a two component, high solids epoxy coating for low temperature curing down to 0°C onto steel, concrete, masonry and non ferrous metals.
PPG Amerlock 2 C is compatible with prepared, damp surfaces with good adhesion on most existing coatings. Proven coating as a bulk rail lining and DTM exterior coating that is surface tolerant and abrasion resistant. Suitable for application onto steel, concrete or masonry, galvanised steel and non ferrous metals.
- Low temperature curing down to 0°C
- High performance self priming universal epoxy
- High Solids
- Low VOC
- Surface Tolerant and Abrasion Resistant
- Resistant to chemicals
Coating performance is proportional to the degree of surface preparation. Remove all loose paint, mill scale and rust. The surface to be coated must be dimensionally stable, dry, clean and free of grease, oil, and other foreign materials. When proper abrasive blast surface preparation is not practical, surfaces should be chipped clean and wire brushed to bare clean material.
|Tintable:||Yes. Please note, bespoke tints are non refundable / exchangeable|
|VOC Content:||163.0g per Litre|
|Suitable Substrates:||For carbon steel, concrete, masonry, galvanized steel, non ferrous metals and stainless steel|
|Application Method:||Brush, Roller or Airless Spray|
|Theoretical Coverage:||8.5 m2 per litre at 100 microns|
|Wet Film Thickness (WFT):|
|Dry Film Thickness (DFT):||100 - 200 microns|
|Pot Life:||2 hours at 10°C|
|Touch Dry:||6 hours at 10°C|
|Overcoatable:||See data sheet|
|Cleaner / Thinner:||PPG Thinner 91-92|
|Shelf Life:||Base 36 months and Hardener 24 months when stored cool and dry|
|Packaging:||Available in 5 and 20 Litres|
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.