PPG Nexa Autocolor P210-982 EHS Medium Hardener is a compatible hardener for PPG Nexa Autocolor paints.
PPG Nexa Autocolor P210-982 EHS Medium Hardener is a compatible Hardener for:
- EHS Turbo Plus™ P498-Line and P494-Line
- HS High-Build, Primer Surfacer P565-1027 /1028
- EHS Turbo Plus Clearcoat P190-1280
For incorporation guidelines to Nex Autocolor topcoats, primers and undercoats, please refer to each individual paints product data sheets.
For professional use only.
The drying times quoted are approximate times and will vary depending on drying conditions and film thickness. Poor ventilation, temperatures below 20°C and excessive film thickness will extend the drying times.
Larger vehicles will need extended stoving times to reach the required metal temperature.
|VOC Content:||Lower than 420 g/l|
|Suitable Substrates:||Compatible hardener for PPG Nexa Autocolor Paints|
|Application Method:||For incorporation guidelines to Nexa Autocolor topcoats, primers & undercoats, please refer to each individual paints product data sheets.|
|Theoretical Coverage:||Approximately 13-14m2 per litre of ready for use paint|
|Wet Film Thickness (WFT):||-|
|Dry Film Thickness (DFT):||50 microns (2 thou) depending in thinning ratio used|
|Pot Life:||2 hours at 20°C with P210-982/984/9652, 1 hour max. with P210-983/9653 To remain compliant DO NOT add extra thinner, activate between coats when necessary|
|Air Dry Dust Free:||40-60 minutes at 20°C|
|Air Dry Handleable:||8 hours at 20°C|
|Air Dry Recoat:||16 hours at 20°C|
|Into Service:||16 hours at 20°C|
|Fully Cured:||days at 20°C|
|Cleaner / Thinner:||Clean gun immediately after use. Thinner P852-179 (See Technical Data Sheet)|
|Packaging:||Available in 1 and 5 Litres|
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.