£7.75 delivery on orders excluding certain products & postcodes *
Remmers Arte Mundit is an environmentally correct cleaning paste on a natural raw material base. The fresh product vulcanises by drying into an elastic rubber with good soil binding capacity. Arte Mundit does not contain any organic solvents, surface active agents or inorganic salts.
The A-components in the Arte Mundit programme differ in their reactivity and compatibility with auxiliary agents. Arte Mundit Type I is a modified latex emulsion that is always used without an additive. After activation with the B component, Arte Mundit Types II, III and V contain varying concentrations of complexing agents and cleaning intensifiers that either volatilize during vulcanisation or are bound into the dry film.
A contamination of the substrate with these substances is therefore not possible.
An introduction to working with Arte Mundit should be given before work is started.
Version | Suitable For | Make Up |
Type I | Physical cleaning for lightly adhering dirt | Pure natural latex dispersion |
Type II | Special cleaner for marble | Natural latex dispersion + 1.01 Kg additive |
Type III | Physical and chemical cleaning for general impurities | Natural latex dispersion + 2.86 Kg additive |
Type V | Especially for cleaning fire residue | Natural latex dispersion + 3.84 Kg additive |
The substrate to be cleaned must be dry and free from dust and loose deposits. All surfaces not to be treated, varnished areas, sensitive metals, etc. should be protected from contact with Arte Mundit (e.g. by covering with PE film).
Temperature of material, surroundings and substrate: +5°C - +30°C. Stir Arte Mundit well, add the B component if required, mix thoroughly and then apply to the substrate which has been coarsely cleaned with a brush, using a suitable tool and covering the entire surface. Fill undercut areas and contours thoroughly with Arte Mundit.
After thorough drying, the film is removed by carefully pulling it off (e.g. from the top left towards the bottom right), keeping tensile force as constant as possible. This is carried out in general approx. 24 hours after application. Avoid waiting times that are longer (more than 3 days) since the elasticity of the film is lost, making it much more difficult to pull off.
When Arte Mundit Type I is used, the surfaces do not need to be washed off afterwards. Surfaces treated with the activated Types II, III and V are cleaned again after the vulcanised material has been pulled off by wiping off with a sponge dampened with just a little clean water, starting at the highest point. If necessary, a medium-hard (nylon) brush can be used for somewhat more intensive cleaning. Use as little water as possible.
Components: | One or Two Part (Type I is One Part, II, III and V are Two Part) |
Type: | Cleaner |
Finish: | - |
Stock Colours: | |
Tintable: | No |
VOC Content: | . |
Volume Solids: | |
Suitable Substrates: | For internal cleaning |
Application Method: | Brush, lambskin roller, filling knife and smoothing trowel. We recommend the use of stainless steel or plastic tools. |
Theoretical Coverage: | m2 per litre at microns |
Wet Film Thickness (WFT): | - |
Dry Film Thickness (DFT): | - |
Induction Time: | - |
Pot Life: | - |
Touch Dry: | - |
Overcoatable: | - |
Fully Cured: | - |
Cleaner / Thinner: | - |
Shelf Life: | At least 12 months in unopened, original containers stored dry, cool and protected from frost. |
Packaging: | Available in Type 1 - 15kg, Type II - 16.01kg, Type III - 17.86kg or Type V - 18.84kg |