Remmers Epoxy FAS 100

Remmers Epoxy FAS 100 is a special, substrate tolerant primer for use as a bonding layer on difficult substrates.

Best Uses

Remmers Epoxy FAS 100 is a priming bonding layer for use on difficult substrates such as tiles or various metals. It is also suitable as a levelling layer or base layer for blinded covers. Epoxy FAS100 is also ideal for producing compression-resistant mortars, and flow coatings or for production of pressure-resistant mortar for height levelling, for use as repair mortar and as epoxy screed in composites and on separating layers.

• Excellent adhesion on many substrates
• Suitable on oily substrates or ones with residual moisture
• Can be subjected to mechanical loads
• High compressive strength and flexural strength
• Physiologically harmless once fully cured
• Suitable for use as primer without broadcasting underneath Remmers PU and EU coatings
• Designed for the use of non-dried screed sand
• Economically efficient thanks to high degree of filling

Application

Prepare the substrate by suitable means, e.g. steel ball jetting or diamond grinding, so that it meets the requirements as per the data sheet. Broken out or missing areas in the substrate should be filled flush with the surface using Remmers PCC systems or Remmers EP mortars.

Bonded screed:
Prime the surface with a suitable primer, such as Remmers Epoxy ST 100, and broadcast it generously with Remmers Quartz 07/12 (approx. 2 kg/m²). Alternatively, it is possible to work wet-on-wet. Pour the material onto the prepared surface and spread using a suitable tool, e.g. a notched trowel.

Screed on separation layer/insulating layer:
The separation layer/insulation layer must be suitable for the use in question. In this application case, no primer is needed. The current technical regulations must be observed.

See data sheet for full application guidance.