£7.75 delivery on orders excluding certain products & postcodes *
Remmers Kiesol is suitable for application on to porous mineral building materials such as fired and sand-lime brick, sandstone, mineral renders.
Kiesol is suitable for subsequent horizontal waterproofing of masonry under gravity up to a degree of moisture penetration of 80%. It is also suitable for subsequent horizontal waterproofing of masonry under low pressure up to a degree of moisture penetration of 95%.
Remmers Kiesol can also be used for priming when protection against the effect of water from behind is required or for general surface improvement.
For Subsequent horizontal waterproofing of masonry
Drilling channel must be free of drill dust.
Priming for protection against the effect of water from behind
The substrate must be clean and free of oil, grease and release agents.
Surface improvement
The substrate must be clean and free of oil, grease and release agents.
Preparation
For injection in a low-pressure procedure, the wall surface must be plugged with Kiesol
and waterproofing grout to at least 30 cm above and below the row of boreholes.
Subsequent horizontal waterproofing of masonry
Pre-inject borehole suspension into hollow masonry. Wait 7 days before carrying out further work.
Re-drill filled boreholes. For injection under pressure, plug the masonry surface with Kiesol and waterproofing grout to a width of 50 cm in the region of the series of boreholes.
Components: | Single Pack |
Type: | Solvent-free, strengthening silicification concentrate |
Finish: | |
Stock Colours: | Clear to yellowish |
Tintable: | No |
VOC Content: | |
Volume Solids: | |
Suitable Substrates: | Porous, mineral building materials such as fired and sand-lime brick, sandstone, mineral renders |
Application Method: | Brush, surface sprayer, airless spraying equipment, pouring vessel, low-pressure injection apparatus |
Theoretical Coverage: | Subsequent horizontal waterproofing: Approx. 1.5 kg/m per 10 cm wall thickness (can vary significantly depending on porosity of masonry) Priming: Approx. 0.1 - 0.3 kg/m² (dilute 1:1 with water) Surface improvement: Approx. 0.2 - 0.4 kg/m² |
Wet Film Thickness (WFT): | |
Dry Film Thickness (DFT): | |
Induction Time: | - |
Pot Life: | - |
Surface Dry: | |
Overcoatable: | Wait 7 days before carrying out further work. |
Fully Cured: | |
Cleaner / Thinner: | Water |
Shelf Life: | At least 36 months in unopened, original containers stored cool, dry and protected from frost. |
Packaging: | Available in 5, 10 and 30 Kg |