*Rustoleum Trade 6060 Reparatie Spack Textured Repair Spray

SKU id21800 ***
This product is now discontinued.

Product Description

Please note, this product has now been discontinued.

Rust-Oleum 6060 Textured Repair Spray is a structural repair agent based on PU dispersion, and is used to repair structural effect (sprayed-on plaster) on walls and ceilings.

Best Uses

Rust-Oleum 6060 Textured Repair Spray is formulated for repairing spray-on spackling on ceilings and walls. For use on plasterwork, gypsum and wood fibre board and concrete. Can also be used as an opaque final finish. For interior use.

Suitable as a structural repair agent for damage to sprayed-on plaster, for example, plaster, plasterboard, chipboard and concrete. Rust-Oleum 6060 Textured Repair Spray can also be used as a sprayed-on plaster finish, and can be finished with all common Mathys wall paints.

Application

The surface must be smooth and even. The surface must be load-bearing, completely cured, clean, dry, and free of dust and grease. Repair flakes and cracks. Remove and/or repair loose and unstable layers.

For new, untreated surfaces

For existing load-bearing surfaces

For existing, non-load-bearing surfaces

For areas with contaminants caused by nicotine, moisture, rust, or soot

The above systems apply as a general description for the most common surfaces. For special applications and/or extensive advice, feel free to contact our technical team.

Bring the aerosol to room temperature. The ideal application temperature is 15°C to 25°C. Before use, thoroughly shake the aerosol for two minutes and then spray a test sample. Tape off or protect adjacent parts. It is possible to spray fine and rough structures by varying the layer thickness and the distance of the spray to the surface.

Rust-Oleum 6060 can be applied as a covering layer as well as lightly sputtering. This is only to create a structure such that, after it dries, the surface will be entirely repainted with a wall paint. If multiple layers are needed, we recommend waiting 10 minutes between layers during the evaporation period.

Tip: we recommend that you start spraying starting at a piece of paper/cardboard. This ensures that, when you start spraying, no other structure is sprayed owing to the sudden pressure. After use, spray the valve clean (hold the top of the aerosol and press the nozzle for about five seconds). Then remove the nozzle and rinse under the tap.

Note: apply when the temperature is between 10°C and 30°C, depending on the desired structure. The temperature of the aerosol influences the structure. When spraying, the aerosol will cool off and the structure becomes rougher. If desired, you can gently heat the aerosol under tepid flowing water to make the structure finer (do not hold the aerosol under a hot tap!).

Recommended Products To Use


Rustoleum Hard Hat 2990 Stain Blocking Aerosol Spray

Rustoleum Hard Hat 2990 Stain Blocking Aerosol Spray

Easy use spray that covers problem stains, nicotine, soot and moisture marks.

£5.43 (£6.52 Inc VAT)