Please note, this product is now discontinued. Please contact our technical team for a suitable alternative.
Rustoleum Floor Paint Slip-Resistant Grade is a single pack polyurethane formulation and will dust proof, seal and transform tired concrete floors.
Rustoleum Floor Paint Slip-Resistant Grade does not require a primer and is an easy to apply single pack polyurethane floor paint that has been blended with an extremely fine aggregate to allow for easy cleaning yet still offer a high degree of slip-resistance.
Rustoleum Floor Paint Slip-Resistant Grade will act as a dust proofer to seal concrete and power floated floors so seal in dust and provide a decorative coating in four colours, Tile Red, Safety Yellow, Mid Grey and White.
Ideally suited to slippery concrete floors Rustoleum Floor Paint Slip-Resistant Grade contains a fine anti-slip aggregate is pre-blended into the paint to produce a more evenly textured finish. The texture of the floor paint is easier to clean than many anti-slip paints, this fine surface also benefits from being easier to clean.
Rustoleum Floor Paint Slip-Resistant Grade is an easy to apply single pack polyurethane floor paint that has been blended with an extremely fine aggregate to allow for easy cleaning yet still offer a high degree of slip resistance.
Rustoleum Floor Paint Slip-Resistant Grade does not require priming but thorough cleaning and if possible a light abrasion to create a key is beneficial is an easy to apply coating that will dry quickly to a tough, slip-resistant finish. So if you require a textured anti-slip floor paint for use in areas where a slippery floor is a hazard that is also easy to clean Rustoleum Floor Paint Slip-Resistant Grade is particularly well suited.
We recommend SuperGrip Safe-T-Epoxy for heavy wear areas and SuperGrip Treadsafe for ramps and wet areas.
Other products available in the Rustoleum Floor Paint range, Floor Paint Epoxy Ester Grade, SuperGrip Safe-T-Epoxy for heavy wear areas and SuperGrip Treadsafe for ramps and wet areas.
- Allow 12 hours before application of a second coat
- Offers a matt finish
- Contains a fine aggregate
- Available in 4 colours tile red, mid grey, yellow, white
- Easy to apply by brush or roller
- Ensure the paint is hard dry (not just touch dry) before return to service
- Application by brush will result in reduced coverage
- Theoretical coverage up to 4m2 per litre allowing for two coats
- Practical coverage depends on many factors such as porosity and roughness of the substrate and material losses during application.
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.