£7.75 delivery on orders excluding certain products & postcodes *
Sika Sikafloor 210 PurCem is used as a scratch coat primer, basecoat and wear coat layer in Sikafloor PurCem® Gloss system build ups, in areas of medium to
heavy loading, high chemical exposure and abrasion.
Sikafloor®-210 PurCem® may only be used by experienced professionals.
The surface must be clean, dry and free of all contaminants such as dirt, oil, grease, coatings and surface treatments, etc. All dust, loose and friable material must be completely removed from all surfaces before application of the product, preferably by vacuum. Pull of strength shall not be less than 1.5 N/mm2. If in doubt apply a test area first.
Mix first the component A (pigmented liquid) thoroughly in the pail 10 – 15 sec. Then add component B (brown liquid) into A and mix together for 15 - 30 sec. using a stirrer in a low speed electric drill until homogenous mixture. Then add component C to A+B mixing simultaneously with larger mixer. When the bag of component C is empty, continue mixing further 3 min depending on the temperature and the mixer efficiency.
Prior to application, confirm substrate moisture content, relative humidity and dew point. As a scratch coat Sikafloor®-210 PurCem® can be applied using a steel trowel. As a body coat Sikafloor®-210 PurCem® can be applied using a toothed trowel or pin screed, to the desired thickness, or a steel trowel. Remove air with a spike roller. For further details please refer to the related system data sheet.
Sika Sikafloor 210 PurCem is used within the following systems:
Components: | Three Pack |
Type: | Water Based Polyurethane |
Finish: | Gloss |
Stock Colours: | Beige, Dusty grey, Grass Green, Maize Yellow, Oxide Red, Pebble Grey, Telegray 2, Night Blue |
Tintable: | No |
VOC Content: | 140 g/L |
Volume Solids: | |
Suitable Substrates: | Used as a scratch coat primer, basecoat and wear coat layer in Sikafloor® Pur-Cem® Gloss system build ups, in areas of medium to heavy loading, high chemical exposure and abrasion. |
Application Method: | Steel Trowel, Toothed Trowel, Pin Screed |
Theoretical Coverage: | 1.9 Kg per m2 per mm |
Wet Film Thickness (WFT): | - |
Dry Film Thickness (DFT): | - |
Induction Time: | - |
Pot Life: | 22 - 25 minutes at 20°C |
Surface Dry: | - |
Overcoatable: | Between 24 and 48 hours at 20°C |
Fully Cured: | - |
Cleaner / Thinner: | Clean all tools and application equipment with Sika Thinner C immediately after use. Hardened / cured material can only be mechanically removed. |
Shelf Life: | Part A: 9 months from date of production, Part B: 12 months from date of production, Part C: 6 months from date of production. Protect from freezing and humidty |
Packaging: | Available in 30 Kg |
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.